User manual BRIGGS & STRATTON 436777

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. Use of these engines in such applications could result in property damage, serious injury (including paralysis), or even death. [. . . ] To prolong starter life, use short starting cycles, not to exceed 15 seconds per minute. Do not tamper with governor spring, links or other parts to increase engine speed. replacement parts must be the same and installed in the same position as the original parts. Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. Check engine oil level Check coolant level Severe thermal burns can occur by escaping steam or hot coolant. Stop engine and allow it to cool before removing radiator cap or reservoir cap and before changing or adding coolant. The coolant level must be between the FULL and LOW, or ADD, marks on the coolant reservoir. If the coolant level is low, add a 50/50% coolant mixture of phosphate-free antifreeze and tap water to the reservoir. If the reservoir is dry, add coolant to both the reservoir and to the radiator. If pressurized steam escapes from the cap, stand back to avoid injury. After all pressure is released, push down and turn the radiator cap counterclockwise to remove. Change engine oil * Replace oil filter * H Change engine oil * Replace oil filter Change coolant Check fan belt tension Clean radiator Check muffler and clean spark arrestor (if equipped) Replace air filter Replace spark plugs Check valve clearance H Service more often when operating under heavy load or in high temperature. CAUTION: Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. With engine off but still warm, disconnect the spark plug wires (F, Figure 2) and keep them away from the spark plugs. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. This warranty is effective for and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Briggs & Stratton 3/LC Service Dealer in our dealer locator map at BRIGGSandSTRATTON. cOM , or by calling 1-800-233-3723 , or as listed in the `Yellow Pagest'. [. . . ] B&S recommends that you retain all your receipts covering maintenance on your engine, but B&S cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the engine owner, you should however be aware that B&S may deny you warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications. You are responsible for presenting your engine to an Authorized B&S Service Dealer as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. [. . . ]