User manual BRIGGS & STRATTON 303700

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. [. . . ] the state of California requires this (Section 4442 of the California Public Resources Code). If replacement parts are required, make sure to use only original equipment replacement parts. Maintenance, replacement, or repair of the emissions control devices and systems may be performed by any non-road engine repair establishment or individual. However, to obtain "no charge" emissions control service, the work must be performed by a factory authorized dealer. WARNING: Replacement parts must be the same and installed in the same position as the original parts or fire could result. Keep the area around and behind the muffler (C) free of any combustible debris (Figure 13). Never start or run the engine with the air cleaner assembly or the air filter removed. CAUTION: Do not use pressurized air or solvents to clean the filter. If the air filter is excessively dirty, replace with a new air filter. Store away from furnaces, stoves, water heaters or other appliances that have pilot lights or other ignition sources because they can ignite gasoline vapors. stale fuel causes acid and gum deposits to form in the fuel system or on essential carburetor parts. To keep fuel fresh, use Briggs & Stratton FRESH START® fuel stabilizer, available as a liquid additive or a drip concentrate cartridge. There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel system. If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into an approved container. the use of a fuel stabilizer in the storage container is recommended to maintain freshness. 5% for each 1, 000 feet (300 meters) above sea level and 1% for each 10° F (5. Service Part Air Filter -- except model 380000 Air Filter -- model 380000 Air Filter Pre-cleaner -- except model 380000 Air Filter Pre-cleaner -- model 380000 Oil -- SAE 30 Oil Filter -- 6 cm long Oil Filter -- 9 cm long Part Number 394018 692519 272490 692520 100028 492932 491056 Service Part Fuel Filter -- with fuel tank Fuel Filter -- with fuel pump Fuel Filter -- without fuel pump Fuel Additive Resistor Spark Plug Long Life Platinum Spark Plug Spark Plug Wrench Spark Tester Part Number 808116 691035 298090 5041 491055 5066 19374 19368 N We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. [. . . ] B&S is not liable to cover failures of Warranted Parts caused by the use of add-on, non-original, or modified parts. Maintenance Any Warranted Part which is not scheduled for replacement as required maintenance or which is scheduled only for regular inspection to the effect of "repair or replace as necessary" shall be warranted as to defects for the warranty period. Any Warranted Part which is scheduled for replacement as required maintenance shall be warranted as to defects only for the period of time up to the first scheduled replacement for that part. Any replacement part that is equivalent in performance and durability may be used in the performance of any maintenance or repairs. [. . . ]