User manual BRIGGS & STRATTON 210800

[. . . ] For replacement parts or technical assistance, record below the engine model, type, and code numbers along with the date of purchase. These numbers are located on your engine (see the Features and Controls page). The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. MM/DD/YYYY Type: Code: Briggs & Stratton does not approve or authorize the use of these engines on 3-wheel All Terrain Vehicles (ATVs), motor bikes, fun/recreational go-karts, aircraft products, or vehicles intended for use in competitive events. [. . . ] Before replacing the fuel filter, drain the fuel tank or close the fuel shut-off valve. replacement parts must be the same and installed in the same position as the original parts. Before replacing the fuel filter (A, Figure 12), if equipped, drain the fuel tank or close the fuel shut-off valve. Use pliers to squeeze tabs (B) on the clamps (C), then slide the clamps away from the fuel filter. Dirt or debris can restrict air flow and cause the engine to overheat, resulting in poor performance and reduced engine life. Use a brush or dry cloth to remove debris from the finger guard/rotating screen (A). Keep the area around and behind the muffler (C) free of any combustible debris (Figure 13). Some models are also equipped with a pre-cleaner that can be washed and reused. To keep fuel fresh, use Briggs & Stratton FRESH START® fuel stabilizer, available as a liquid additive or a drip concentrate cartridge. There is no need to drain gasoline from the engine if a fuel stabilizer is added according to instructions. Run the engine for 2 minutes to circulate the stabilizer throughout the fuel system. If gasoline in the engine has not been treated with a fuel stabilizer, it must be drained into an approved container. the use of a fuel stabilizer in the storage container is recommended to maintain freshness. Store away from furnaces, stoves, water heaters or other appliances that have pilot lights or other ignition sources because they can ignite gasoline vapors. Fuel Filter -- engine without fuel pump Fuel Filter -- engines with fuel pump 5% for each 1, 000 feet (300 meters) above sea level and 1% for each 10° F (5. Fuel Filter -- engine without fuel pump Fuel Filter -- engines with fuel pump N We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. Briggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at BRIGGSandSTRATTON. cOM , or by calling 1-800-233-3723 , or as listed in the `Yellow Pages'. Implied warranties, including those of merchantability and fitness for a particular purpose, are limited to one year from purchase, or to the extent permitted by law and all implied warranties are excluded. [. . . ] Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled replacement point for the part. Add on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any non exempted add on or modified parts by the owner will be grounds for disallowing a warranty claim. The manufacturer will not be liable to warrant failures of warranted parts caused by the use of a non exempted add on or modified part. [. . . ]