User manual BRIGGS & STRATTON 195499 SCHEMATICS

[. . . ] Every effort has been made to ensure that information in this manual is accurate and current. However, we reserve the right to change, alter or otherwise improve the product and this document at any time without prior notice. The icons on the warning tag are shown and described in detail later in the next section. Obey all safety messages that follow this symbol to avoid possible injury or death. [. . . ] Always wear eye protection when using this equipment or in vicinity of where equipment is in use. Before starting the pressure washer, be sure you are wearing adequate eye protection. Check for properly tightened hose connections (high pressure and water supply) and there are no kinks, cuts, or damage to high pressure hose. Be sure to read "Safety Rules" and "How To Use Pressure Washer" before using pressure washer. If you have any problems operating your pressure washer, please contact the local Briggs & Stratton service center. To start your pressure washer for the first time, follow these instructions step-by-step. This starting information also applies if you have let the pressure washer sit idle for at least a day. Place pressure washer near an outside water source capable of supplying water at a flow rate greater than 3. 0 gallons per minute and no less than 20 PSI at pressure washer end of garden hose. Check that high pressure hose is tightly connected to spray gun and to pump. Running engine gives off carbon monoxide, an odorless, colorless, poison gas. The pressure washer must be at least 5 feet from structures having combustible walls and/or other combustible materials. Keep at least 3 feet of clearance on all sides of pressure washer for adequate cooling, maintenance and servicing. A pressure washer produces a high pressure spray which increases risk of injury and damage to unit. High pressure spray could cause you to fall if you are too close to the cleaning surface. Keep spray nozzle between 8 to 24 inches away from cleaning surface. Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location. Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back. IMPORTANT: Simply shutting OFF engine will not release pressure in the system. When the engine has shut down, squeeze the trigger on the spray gun to relieve the pressure in the hose. If you run the engine on your pressure washer for 3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125°F. Apply high pressure spray to a small area, then check surface for damage. [. . . ] Transportation charges on parts submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for the time periods and subject to the conditions stated below. For warranty service, find the nearest Authorized Service Dealer in our dealer locator map at www. Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and exclusion may not apply to you. [. . . ]