User manual BRIGGS & STRATTON 113400

[. . . ] GB D DK E F GR I N NL P S SF Operating & Maintenance Instructions Betriebsanleitung & Wartungsvorschriften Drifts- og vedligeholdelsesvejledning Instrucciones de Mantenimiento & Operación Instructions d'utilisation et de maintenance Ïäçãßåò Ëåéôïõñãßáò & ÓõíôÞñçóçò Istruzioni per l'uso e la manutenzione Anvisninger for bruk og vedlikehold Gebruiksaanwijzing Instruções de operação e de manutenção Instruktionsbok Käyttö & Huolto-ohjeet Model 200000 Power Built 1350/1450 Series Intek I/C 1350/1450 Series I/C 1450 Series Model 120000 Power Built 825/850/875/900 Series Intek I/C 825/850/875/900 Series I/C 825/850/875 Series Model 150000 Power Built 1100/1125 Series Model 210000 Power Built 1500/1575 Series Intek I/C 1500/1575 Series BRIGGSandSTRATTON. com E Copyright Briggs & Stratton Corporation Milwaukee, Wisconsin 53201 U. S. A. Form No. 1 1 12 11 10 2 8 13 3 7 9 4 14 16 5 6 15 Fig. 2 Ë Ì ** * °F °C -20 -30 -20 0 -10 20 32 0 40 10 60 20 80 30 100 40 Í Ê Î Fig. 4 Ê Ë Ë Ê Ê Ì OFF Ë Ì Í ON Í Note: (This note applies only to engines used in the U. S. A. ) Maintenance, replacement or repair of the emission control devices and systems may be performed by any nonroad engine repair establishment or individual. [. . . ] To assure smooth operation, keep governor linkage, springs and controls Ê free of debris. Chaff or debris may clog engine's air cooling system, especially after prolonged operation. Remove blower housing and clean as shown Î. STORAGE Engines stored over 30 days need to be protected or drained of fuel to prevent gum from forming in fuel system or on essential carburetor parts. For engine protection, we recommend use of Briggs & Stratton Fuel Stabilizer. Note: If stabilizer is not used or if engine is operating on gasoline containing alcohol, e. g. gasohol, remove all fuel from tank and run engine until it stops from lack of fuel. Remove spark plug and pour about 15 ml (1/2 oz) of engine oil into cylinder. Clean chaff and debris from cylinder and cylinder head fins, under finger guard and behind muffler. Perform operation checks, see maintenance schedule, before starting engine. Briggs & Stratton Corporation (B&S), the California Air Resources Board (CARB) and the United States Environmental Protection Agency (U. S. EPA) Emissions Control System Warranty Statement (Owner's Defect Warranty Rights and Obligations) California, United States and Canada Emissions Control Defects Warranty Statement The California Air Resources Board (CARB), U. S. EPA and B&S are pleased to explain the Emissions Control System Warranty on your small off-road engine (SORE). In California, new small off-road engines model year 2006 and later must be designed, built and equipped to meet the State's stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later must meet similar standards set forth by the U. S. B&S must warrant the emissions control system on your engine for the periods of time listed below, provided there has been no abuse, neglect or improper maintenance of your small off-road engine. Your emissions control system includes parts such as the carburetor, air cleaner, ignition system, fuel line, muffler and catalytic converter. Also included may be connectors and other emissions related assemblies. Where a warrantable condition exists, B&S will repair your small off-road engine at no cost to you including diagnosis, parts and labor. Briggs & Stratton Emissions Control Defects Warranty Coverage Small off-road engines are warranted relative to emissions control parts defects for a period of two years, subject to provisions set forth below. If any covered part on your engine is defective, the part will be repaired or replaced by B&S. Owner's Warranty Responsibilities As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your Operating and Maintenance Instructions. B&S recommends that you retain all your receipts covering maintenance on your small off-road engine, but B&S cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. As the small off-road engine owner, you should however be aware that B&S may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications. [. . . ] To avoid misunderstanding which might occur between the customer and the Dealer, listed below are some of the causes of engine failure that the warranty does not cover. Normal wear: Engines, like all mechanical devices, need periodic parts service and replacement to perform well. Warranty will not cover repair when normal use has exhausted the life of a part or an engine. Improper maintenance: The life of an engine depends upon the conditions under which it operates, and the care it receives. [. . . ]