User manual BREIL VD57

[. . . ] Push the crown back in to the normal position in accordance with a time signal. Note: When setting the minute hand, first advance it 4 to 5 minutes ahead of the desired time and then turn it back to the exact minute. The measured time is indicated by the small chronograph hands that move independently of the center hands. [. . . ] ⷠThe chronograph minute hand moves correspondingly with the chronograph second hand · The hands move quickly if the respective buttons are kept pressed 3. When the battery is replaced, the time information stored in the built-in IC and the time indicated by the hands do not correspond with each other. Before using the watch, therefore, be sure to reset the hands to the "0" position, following the procedure below. ⷠIn case any of the hands should move improperly, follow the procedure below to adjust the hand movement. Keep "A" and "B" pressed at the same time for 2 seconds, and then release the buttons. The chronograph second hand turns half a circle counterclockwise and the returns where it was. The chronograph 1/10 second hand turns a full circle clockwise and stops. Press "B" repeatedly to reset the chronograph second and minute hands to the "0" position · the "0" position of the chronograph 1/10 second differs depending on the models. (Some models have the "0" position of the chronograph 1/10 second hand at 3 and 9 o'clock sides at the small dial. In that case, check if the hand is level with its both ends pointing to those "0" positions) · The chronograph minute hand moves correspondingly with the chronograph second hand. ⷠThe hands move quickly if the respective buttons are kept pressed. Turn the crown clockwise or counterclockwise to set the hour and minute hands to the desired time. - In order to prevent water coming into contact with the internal mechanism, never pull the crown out when the watch is wet. - If any watches designed for sportswear or use in water come into contact with salt water or heavy sweating, they should be rinsed in fresh water and dried thoroughly. During daily use Can be worn while swimming but not diving Suitable for skin-diving. - Contact with water may cause a deterioration in the quality of some leather straps. - As internal parts of the watch can retain moisture, when the outside temperature is lower than the inside, the watch glass may mist-up. This phenomenon is purely temporary and should not create any problems. [. . . ] The watch case and strap may discolour if they come into contact with mercury from a broken thermometer or other equipment. Keeping the watch clean Use an absorbent soft cloth to clean off any dirt or damp from the watch glass. Wearing the watch when the strap or back of the case is dirty can cause skin irritation. [. . . ]