User manual BREIL 3S10

[. . . ] Alarm ON/OFF Pulling the alarm button out activates the alarm (ON), pressing it back in de-activates it (OFF). If button is pressed while the watch is in normal time mode, a confirmation "bip" is heard. The second hand moves rapidly to 0 and the watch is in chronograph mode. Is pressed while the watch is in chronograph mode, a confirmation "bip" is · if button heard. [. . . ] If the chronograph is started at the same time as the start of the distance measurement and stopped after one kilometre, the average speed can be calculated from the position of the second hand. If the vehicle covers a distance of one kilometre in 45 seconds, then the average approximate speed is 80 km/h. The telemeter is a distance indicator which allows distance to be calculated on the basis of the speed of sound. It is useful, therefore, for aviation, navy army and artillery purposes. The hand is started the second a flash, smoke or lightning is seen and stopped when the actual sound is heard. The distance, from 1 to 20 kilometres, between the observer and the explosion or storm is read from the telemetry scale. Pull the crown out one stop (1) The date can be changed rapidly by rotating the crown in a clockwise direction (Note) The watch changes the date between 00. The date will not change if the alarm is set or adjusted during these hours. This watch incorporates a mechanism which moves the second hand at two second intervals instead of one when the battery is low. The words "WATER RESISTANT" may sometimes be abbreviated to "WATER RESIST". ­ In order to prevent water coming into contact with the internal mechanism, never pull the crown out when the watch is wet. ­ If any watches designed for sportswear or use in water come into contact with salt water or heavy sweating, they should be rinsed in fresh water and dried thoroughly. ­ Contact with water may cause a deterioration in the quality of some leather straps. During daily use Can be worn while swimming but not diving Suitable for skin-diving Suitable for scuba diving *Always keep the crown in its normal position. ­ As the internal parts of the watch can retain moisture, when the outside temperature is lower than the inside, the watch glass may mist-up. This phenomenon is purely temporary and should not create any problems. However, if it persists for any length of time, the watch should be checked by the shop where it was purchased or by the nearest Authorised Service Centre. Temperature Do not leave the watch exposed to direct sunlight or temperature extremes for long periods of time. [. . . ] Keeping the watch clean Use an absorbent soft cloth to clean off any dirt or damp from the watch glass. Wearing the watch when the strap or back of the case is dirty can cause skin irritation. Metal bands: use a toothbrush and soapy warm water to wash the dirt off. Leather straps: gently rub the face of the strap using a soft dry cloth. [. . . ]