User manual BREAK A BEAM M2510

[. . . ] Caution: To conform with the EMC directive (2004/108/EC), do not detach the plug from the power cord. Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. • • • • • • • 3 2 Your CD Soundmachine Introduction With this CD Soundmachine, you can: • listen to FM radio; • enjoy audio from discs, and other external audio devices; • program the play sequence of tracks. The unit offers you Dynamic Bass Boost (DBB) to enrich sound. What's in the box Check and identify the contents of the package: • Main unit • AC power cord • Quick start guide EN 4 Overview of the main unit a b c d e f k j i h g l m n o p a - VOLUME + • Adjust volume. • Erase a program. EN f Display panel g PROG • In CD mode, program the play sequence of tracks. [. . . ] • Search within a track. 5 l FM antenna • Improve FM reception. p DBBswitch • ON/OFF: turn dynamic bass boost on or off. 3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. ___________________________ Connect power The unit can be powered by either AC power or batteries. Option 1: AC power Warning supply voltage corresponds to the voltage printed on the back or the underside of the unit. When you disconnect the AC power, always pull the plug from the socket. Make sure that the power Connect the AC power cord to: • the AC~ MAINS socket on the unit. • the wall socket. Note •• To switch the unit off completely, disconnect the power cord from the power supply socket. EN 6 Turn on Switch the source selector to FM, Audio-in, or CD. AC~MAINS Turn off Switch the source selector to OFF. Option 2: Battery power Caution •• Risk of explosion!Keep batteries away from heat, •• Batteries contain chemical substances, so they should be disposed of properly. To ensure good play quality, clean the disc lens with Philips CD lens cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. 9 EN 6 Troubleshooting Warning •• Never remove the casing of this device. 7 Notice To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this device, check the following points before requesting service. If the problem remains unsolved, go to the Philips Web page (www. philips. com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available. No power •• Ensure that the AC power plug of the unit is connected properly. •• Insert the batteries with their polarities (+/– signs) aligned as indicated. No response from the unit •• Take out the batteries and turn on the unit again. •• Disconnect and reconnect the AC power plug, then turn on the unit again. [. . . ] •• Disconnect and reconnect the AC power plug, then turn on the unit again. •• Wait until the moisture condensation at the lens has cleared. Poor radio reception •• Increase the distance between the unit and your TV or VCR. [. . . ]