User manual BRAUN PROSTYLE

[. . . ] Notice: While ironing, do not turn the steam regulator beyond the red range. For extra steam, power shot and «jet» of steam, the temperature selector must be set within the continuous red range. vario plus steam (not model 8520) Press the steam plus button (7) for max. [. . . ] The pilot light goes off when the desired 8 This is normal and in no case indicates a fault of the iron. The «auto-off» pilot light will flash when the automatic shut-off is activated. ­ horizontally on its sole plate for about 30 seconds or ­ vertically on its heel rest for about 15 minutes. When the «auto-off» pilot light stops flashing, the electrical power is on again. Out from the sole plate when the steam regulator is turned clockwise into the anticalc area. Wait for the sole plate to cool down, then clean it as described above. Then refill the tank with water, heat up the iron and press the power shot button 4 times to rinse the iron before ironing (I 12-13). (Model 8595/8590 only) Before attaching the Textile Protector for the first time, iron approximately 2 minutes without the Textile Protector. The Braun Textile Protector protects delicate fabrics from heat damage and makes it possible to iron most dark fabrics without an intermediate cloth. To check the reaction of your fabrics before you start ironing, we recommend that you iron a small section of material on the reverse side. With the Protector, you are able to iron delicate fabrics with the temperature setting «· » or «max», so that you can use all steam functions your iron offers. After having attached the Textile Protector, wait about 1 1/2 minutes before you start ironing. Problem Drops coming out of the steam vents Remedy Turn the steam regulator anti-clockwise to reduce the steam or turn it off. Take longer intervals when pressing the «jet», power shot or steam plus button. «jet» of steam does not function Less steam develops or no steam at all Calcium particles coming through the steam vents To clean the sole plate, use steel wool. immerse the anticalc valve in vinegar (not vinegar essence) or lemon juice for minimum 30 minutes. [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. [. . . ]