User manual BRAUN PROFESSIONAL CARE 3000

[. . . ] ⷠThis appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are supervised by a person responsible for their safety. ⷠIf the product is dropped, the brush head should be replaced before the next use even if no damage is visible. ⷠDo not place or store the charger where it can fall or be pulled into a tub or sink. ⷠDo not reach for a charger that has fallen into water. [. . . ] ⷠTo maintain the maximum capacity of the rechargeable battery, unplug the charging unit and fully discharge the handle with regular use at least every 6 months. Please note: If the charge indicator light is not flashing immediately, continue charging. Wet brush head and apply toothpaste; you can use any kind of toothpaste. To avoid splashing, guide the brush head to your teeth before switching on the appliance. Guide the brush head slowly from tooth to tooth, spending a few seconds on each tooth surface. Brush the gums as well as the teeth, first the outsides, then the insides, finally the chewing surfaces (see picture 5, page 2). brushing modes (depending on model) «Daily Clean» Exceptional mouth cleaning. This mode is best used with the Braun Oral-B Precision Clean brush head. We do not recommend using the Braun Oral-B 3D WHITE brush head with braces. Children under 12 years old should not use the Braun Oral-B 3D WHITE brush head. All three brush heads feature light blue INDICATOR bristles to help you monitor brush head replacement need. With thorough brushing, twice a day for two minutes, the blue color will fade halfway approximately within 3 months, signalling it is time to replace the brush head. How to switch between modes: · When pressing the on/off button (c) your toothbrush automatically starts in the «Daily Clean» mode. To turn off your toothbrush from the «Whitening» mode, push the on/off button once more. ⷠIf you wish to turn off your toothbrush from the «Daily Clean» or «Sensitive» mode, push and hold down the on/off button until the motor stops. Pressure Sensor Helping protect your teeth and gums from hard brushing, your toothbrush has a pressure control feature installed. If too much pressure is applied, the red pressure sensor light (b) will light reminding you to reduce pressure (see picture 3, page 2). Periodically check the operation of the pressure sensor by pressing lightly on the brush head during use. [. . . ] Disposal can take place at an Oral-B Braun Service Centre or at appropriate collection points provided in your country. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use, especially regarding the brush heads, as well as defects that have a negligible effect on the value or operation of the appliance. [. . . ]