User manual BRAUN NESCUP NC 1000

[. . . ] For optimum taste we also recommend rinsing the machine interior by following the procedure below: · Remove the water filter (L) from its foil and immerse it in a large glass or cup filled with water for 10 minutes. Fill the water tank (C) to the maximum mark with fresh, cold drinking water (see II). Now turn the coffee/water selector (Q) into 13 This machine is intended for household use only. Before plugging in, check that your voltage corresponds with the voltage printed on the bottom of the machine. [. . . ] , Nescafé Decaffeinated according to the dosage indicated on the coffee packaging. Select the manual button (H) first, then press the cup (K) or mug (J) button. The cup or mug signal lights up indicating that coffee preparation is in process. the flashing power/stand-by signal indicates that the integrated ventilator is running. When it lights up continuously, the machine has switched to the energy saving stand-by mode. If you change the coffee you use in the container, check the coffee strength setting as this may vary between different coffees. If the machine has not been used for a longer period of time (2-3 weeks), rinse and refill the water tank (C), rinse the interior of the machine and check whether you may want to exchange the remaining coffee in the container (A) before using it the next time. To ensure best coffee quality, Nescafé Nescup ® by Braun has been optimised for use with the premium Nescafé Gold Blend. Braun Nescafé Nescup® is equipped with a water filter that filters unfavourable chemicals out of the water to improve the quality of your beverage significantly. Moreover, it protects your machine against scale build-up and extends its lifetime. When the water filter exchange signal (E) lights up, you need to replace the water filter to ensure best quality of your coffee. to insert the water filter cartridge , proceed as follows: · Unpack the water filter cartridge, and immerse it in a large glass or cup filled with water for 10 minutes. Empty the cup if needed, place it back on the drip tray and press the mug button (J). Remember to replace the seal (V) when reassembling the brewing unit (U). When re-inserting the brewing unit, ensure it is firmly inserted by pressing against its back panel. coffee Container · Disassemble the coffee container (A) and clean the glass either with a dry cloth or in hot water (see X). After cleaning the coffee container make sure it is completely dry prior to re-filling with instant coffee. If the lid of the coffee container is blocked with caked coffee, disassemble it by taking out the stopper, turning the ring left and pulling out the piston (see IX, 1­4). Clean all other parts with hot water and ensure everything is dry before reassembly. machine Exterior · Never clean the machine under running water and never immerse it in water. When moving the machine, remove the water tank (C) from the unit first. Press the manual button (H) without adding any instant coffee and press the mug button (J). [. . . ] Make sure that the unit is plugged in, switched on and the water tank (C) is full. Disassemble the coffee container (A) and clean the lid (see «Cleaning ­ Coffee Container»). Coffee is too weak even if coffee selector is in «max» strength or only hot water is coming out. Problem Machine does not produce coffee, only hot water is coming out. [. . . ]