User manual BRAUN CRUZER 3

[. . . ] 1 2 3 4 4a 4b 5 6 7 8 9 10 Foil protection cap Shaver foil Cutter block Rotating styler Wide shaper (28 mm) Narrow shaper (14 mm) Charging light On/off switch Trimming attachment Beard length selector Special cord set Short beard attachment Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. ⷠUsing the special cord set, connect the shaver to an electrical outlet with the motor switched off. ⷠWhen charging for the first time, leave the shaver to charge continuously for 4 hours. [. . . ] ⷠTo maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Using the rotating styler (4) The wide shaper (4a) evenly cuts and trims large areas (c). it is ideal for shaping sideburns , moustaches and partial short beards. The wide shaper is provided with safety rips and a gliding strip for less irritation and easy gliding. While stretching the skin, guide the wide shaper against the direction of hair growth. The narrow shaper (4b) precisely defines lines and edges (d), being ideal for precise contouring. To use the narrow shaper, push up the styler and turn it 180°. Place the trimming attachment onto the shaver foil (2) and press it against the shaver housing until it snaps into place with a click. Press the beard length selector (8) (e) and slide it up in order to set the desired beard length (length settings from top to bottom 1. The short beard attachment (10) is perfectly suited for creating a stubble look and maintaining it. Attach the short beard attachment the same way as the trimming attachment (7). Warning: Detach the hand-held part from the power supply before cleaning it in water. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaving head under hot running water (g). A natural based soap may also be used provided it contains no particles or abrasive substances. ⷠNext, switch off the shaver, remove the shaver foil and the cutter block. ⷠIf you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil (i). [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear and tear (e. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. [. . . ]