User manual BRAUN COOLTECH CT5CC

[. . . ] Children should be supervised to ensure that they do not play with the appliance. Clean&Charge Station (models CT6cc/ CT5cc/CT4cc/CT3cc/CT2cc only) To prevent the cleaning fluid from leaking, ensure that the Clean&Charge station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface. [. . . ] € Deactivation: By pressing the on/off switch for 3 seconds the shaver is unlocked again. € Switch the shaver on and rinse the shaver head under hot running water. € Next, switch off the shaver, remove the Foil & Cutter cassette and let it dry. € If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the Foil & Cutter cassette. Alternatively, you may clean the shaver using a brush: • Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat surface. Tips for a perfect dry shave For best results, Braun recommends you to follow 3 simple steps: 1. Stretch your skin and shave against the direction of your beard growth. Cooling Note: The cooling sensation experienced may differ from person to person. Activation: To activate the cooling function, press the cooling switch (3) during shaving. For best cooling performance, we recommend to wait a few seconds after the cooling function has been activated. In the cooling switch (3) Low battery: The symbol starts blinking when the battery is running low and there is not enough energy left for the cooling function. You should be able to finish your shave with activated cooling function. You can deactivate the cooling function by pressing the cooling switch again. Clean&Charge station (models CT6cc/CT5cc/CT4cc/CT3cc/CT2cc) The Clean&Charge station has been developed for cleaning, charging, lubricating, disinfecting and storing your Braun shaver. 13 14 15 16a 16b 17 18 Station power socket Lift button for cartridge exchange Station-to-shaver contacts Level indicator Status light Start button Cleaning cartridge Installing the Clean&Charge station (see fig. E) • Remove the protection foil from the Clean&Charge station display. € Press the lift button (14) at the rear side of the Clean&Charge station to lift up the housing. € Hold the cleaning cartridge (18) down on a flat, stable surface (e. € Slide the cartridge from the rear side into the base of the station until it snaps into place. € Using the special cord set (10), connect the station power socket (13) to an electrical outlet. Charging the shaver in the Clean&Charge station Insert the shaver head down into the Clean&Charge station. [. . . ] When cleaning the shaver head with water only use hot water and from time to time some liquid soap (without abrasive substances). If the shaver is regularly cleaned with water, apply a drop of light machine oil on top of the foil once a week for lubrication. Soak the Foil & Cutter cassette into hot water with a drop of dish liquid. You can use the shaver like this or turn on the cooling function and wait a few seconds until it is activated again. [. . . ]