User manual BRAUN CONTOUR 5874

[. . . ] Our products are designed to meet the highest standards of quality, functionality and design. Warning Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. [. . . ] ⷠOnce the shaver is completely charged, discharge the shaver through normal use. Maximum battery capacity will only be reached after several charging/discharging cycles. ⷠIf the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. ⷠTo maintain 100% shaving performance, replace the shaver foil and cutter block, when the replacement light (8) comes on (after about 18 months), or when the shaving parts are worn. Warning: Detach the hand-held part from the power supply before cleaning it in water. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. ⷠNext, switch off the shaver, remove the shaver foil and the cutter block. ⷠIf you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil. Alternatively, you may clean the shaver using the brush provided: · Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil. The replacement light will remind you during the next 7 shaves to replace the shaving parts. After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (9) for at least 3 seconds to reset the counter. [. . . ] Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation. [. . . ]