User manual BRAUN 8975

[. . . ] Do not place, store or charge the appliance where it can fall or be pulled into a tub or sink. When not using for a longer period of time, unplug this appliance from the electrical outlet. This appliance is provided with a special cord set with integrated Safety Extra Low Voltage power supply. [. . . ] Model 8975: When the shaver is fully charged, all five charging lights (7) will light up (20% per light), provided the shaver is connected to an electrical outlet or switched on. Model 8970: The green single charging light (7) shows that the shaver is being charged. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity. Switch positions off = (switch is locked) Press and push up the switch to operate the shaver: on = Shaving with the pivoting head (the pivoting cutting system automatically adjusts to every contour of your face). Fix = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. It can take up to 14-21 days for your beard to adjust to the new shaving system. Shave before washing your face or taking a shower, as skin tends to swell after washing. To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light (9) comes on (after about 18 months), or when worn. The red low charge light (8) flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. Press the release buttons to lift the shaver foil (do not remove the foil completely). However, do not clean the shaver foil nor the cutter block with the brush as this may damage them. Put a drop of light machine oil onto the long hair trimmer and the shaver foil. Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (9) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil and cutter block: 8000 series) The replacement light will remind you during the next 7 shaves to replace the shaving parts. After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (10) for at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (through normal use) every 6 months approximately. [. . . ] This guarantee does not cover any product, which has been damaged by dropping, tampering, wrong current, servicing performed or attempted by unauthorized service agencies, misuse or abuse, kinks in the shaver foil as well as the normal wear of the shearing parts. exclusion of Warranties: The foregoing warranty is the sole warranty offered by Braun Canada. Braun Canada hereby disclaims any implied warranty or merchantability or fitness for any particular purpose. [. . . ]