User manual BRAUN 8585

[. . . ] Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. Do not use this appliance with a damaged or broken foil, as serious facial injuries may occur. To disconnect, turn all controls to «off», then remove plug from outlet. [. . . ] While cleaning is in progress, the respective cleaning program light will flash. Each cleaning consists of several cycles (where the cleaning fluid is flushed through the shaver head) and a heat drying period. Also, if the shaver is taken out prematurely and is not dry, its electronics could be harmed. When the program is finished, the blue «clean» light will shine. You can release the shaver by pushing the «start cleaning» button. If the shaver is locked into the Clean&RenewTM station, push the «start cleaning» button (2) to release the shaver and take it out. Switch positions 0 = Off (switch is locked) Press and push up the switch to operate the shaver: 1 = Shaving with the pivoting head (the pivoting cutting system automatically adjusts to every contour of your face). 2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. Shave before washing your face or taking a shower, as skin tends swell after washing. ⷠThe dryer the skin, the closer the shaving results will be. ⷠTo maintain 100% shaving performance, replace your foil and cutter block every 18 months or when worn. Shaving with the cord If the shaver is completely discharged and you do not have the time to recharge in the Clean&RenewTM station, you may also shave with the shaver connected to an electrical outlet via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&RenewTM station and proceed as described above in the section «Before shaving». With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. Quick cleaning Press the foil release buttons (12) to lift the shaver foil (do not remove the foil completely). Thorough manual cleaning Manual cleaning is recommended only when the Clean&RenewTM station is not available, e. Using the brush, clean the cutter block and the inner area of the pivoting head. If you do not use the Clean&RenewTM station for a longer period of time, you should apply a drop of light machine oil onto the shaver foil. [. . . ] If the shaver exhibits such a defect, Braun will, at its option, either repair or replace it for the consumer without charge. This warranty does not cover foils, cutter blocks or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. [. . . ]