User manual BRAUN 790 CC-4

[. . . ] This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are supervised by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance. to prevent the cleaning fluid from leaking , ensure that the Clean&Renew station is placed on a flat surface. [. . . ] If you remove the shaver just after the program has finished, wipe off the shaver head with a tissue to avoid dripping. Stand-by mode 10 minutes after completing the charging or cleaning session, the Clean&Renew station switches to the stand-by mode: The indicators of the Clean&Renew station turn off. The shaver display z shows the charge status of the battery on the left, and the hygiene status on the right. (6 dark segments are shown on each side when the battery is fully charged and the shaver is hygienically clean). Low charge indicator: The low charge indicator provided with a red frame blinks to indicate that the charge has dropped below 20%. When the shaver is being used, the hygiene segments will gradually disappear. Once the shaver is returned to the station, the system will automatically select the appropriate cleaning program and restore the segments to maximum hygiene. Given that rinsing the shaver under tap water is not as hygienic as the cleaning station, the hygiene segments will only restore themselves when the shaver has been cleaned in the Clean&Renew station. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. Personalizing your shaver With the (­) e and (+) r buttons you can choose the best setting for shaving different areas of your face and as per your specific needs. The different settings are indicated by the pilot light incorporated in the on/off switch w: White (for a thorough comfortable shave in sensitive areas of your face such as neck) When switching on next time, the last used setting will be activated. How to use Press the on/off switch w to operate the shaver: · The pivoting shaver head and floating foils automatically adjust to every contour of your face. Under the nose) slide the shaver head «lock» switch 0 to the back position to lock the pivoting head at an angle. Stretch your skin and shave against the direction of your beard growth. Shaving with the cord If the shaver has run out of power (discharged), and you do not have the time to recharge it in the Clean&Renew station, you may also shave with the shaver connected to an electrical outlet via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving». With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricants, which may leave residual marks on the outer foil frame after cleaning. [. . . ] Replacing the Foil & Cutter cassette / reset To maintain 100% shaving performance, replace the Foil & Cutter cassette 8, when the replacement symbol lights up on the shaver display z (after about 18 months) or when cassette is worn. The replacement symbol will remind you during the next 7 shaves to replace the Foil & Cutter cassette. After you have replaced the Foil & Cutter cassette, use a ball-pen to push the reset button t for at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. [. . . ]