User manual BRAUN 7765

[. . . ] Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. 1 2 3 4 5 6 Foil protection cap Shaver foil Cutter block Foil release button Long hair trimmer Switch 7 8 9 10 11 Charging lights (green) Low-charge light (red) Pilot light Shaver socket Special cord set First charging: Using the special cord set, connect the shaver to an electrical outlet with the switch on position «0» and charge it for at least 4 hours (plug might get warm). The SmartLogic inside your shaver automatically monitors the condition of the batteries as well as the charging/discharging processes and adapts them to your personal shaving patterns. ⷠFrom now on, the SmartLogic inside your shaver will ensure optimal care of the battery. [. . . ] Automated cleaning The Braun Clean&RenewTM (with 7790 and 7785 models only) automatically takes care of all cleaning and lubrication needs of your shaver. Manual cleaning For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely). for a thorough cleaning (weekly) , remove the shaver foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block with Braun cleaning agents. If your skin is very dry and you notice a reduced operation time of the shaver, apply a drop of light machine oil onto the shaver foil. Replacing the shaving parts To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations. Please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver. important · Only use the low voltage adaptation system supplied with the shaver. ⷠIn order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface or use the wall holder (not included in all versions). Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. ⷠDo not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. Wall holder (not included in all versions) Mount the wall holder with plugs and screws to a smooth wall so that the standing surface for the Clean&RenewTM is horizontal. [. . . ] When the «cartridge» light illuminates constantly, the cleaning function is locked and a new cartridge has to be installed. ⷠA cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Clean the housing from time to time with a damp cloth, especially the opening where the shaver rests. [. . . ]