User manual BRAUN 7680

[. . . ] 1 2 3 4 5 6 Foil protection cap Shaver foil Cutter block Foil release button Long hair trimmer Switch 7 8 9 10 11 Display Info key Pilot light Shaver socket Power supply cord set First charging: Using the power supply cord set, connect the shaver to the mains with the switch on position «0» and charge it for at least 4 hours (plug might get warm). From now on, the «SmartLogic» inside your shaver will ensure optimal care of the battery. [. . . ] Switch positions 0 = Off (switch is locked) Press and push up the switch to operate the shaver 1 = Shaving with the pivoting head The pivoting cutting system automatically adjusts to every contour of your face. 2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. Shaving with the cord If the rechargeable battery is discharged, you may also shave with the shaver connected to the mains via the power supply cord set. (If the shaver does not run immediately, charge it with the switch on position «0» for approx. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. ⷠReplace the shaver foil and cutter block every 11/2 years, or when the parts are worn, to ensure optimum shaving performance. Automated cleaning The Braun Clean&Charge takes care of all cleaning and lubrication needs of your shaver. Manual cleaning For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely). for a thorough cleaning (weekly) , remove the shaver foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block with Braun cleaning agents. [. . . ] This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. [. . . ]