User manual BRAUN 7630

[. . . ] The «SmartLogic» inside your shaver automatically monitors the condition of the batteries as well as the charging/discharging processes and adapts them to your personal shaving patterns. ⷠFrom now on, the «SmartLogic» inside your shaver will ensure optimal care of the battery. If, for instance, it is your habit to never let the batteries get low, the «SmartLogic» will recognize this, look for a pause when you are likely to not use the shaver and completely discharge and then recharge your shaver to recondition the batteries (every six months at the most, and only when necessary). However, the maximum battery capacity will only be reached after several charging/discharging cycles. [. . . ] About every four weeks, clean the cutter block with Braun cleaning agents. If your skin is very dry and you notice a reduced operation time of the shaver, apply a drop of light machine oil onto the shaver foil. Replacing the shaving parts The shaver foil and cutter block are precision parts that, in time, are subject to wear. Replace your foil and cutter block every 18 months and get a 25% better shave. ) (* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months. This appliance is provided with nickel-hydride rechargeable batteries. To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC). During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver. important · Only use the low voltage adaptation system supplied with the shaver. ⷠIn order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface or use the wall holder (not included in all versions). Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. ⷠDo not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. 12 13 14 15 16 17 Lift button for cartridge exchange Contact bow Release button Operation mode selector «clean» light: cleaning process indicator «charge» light: charging process indicator 18 «cartridge» light: cartridge replacement indicator 19 Cleaning cartridge Wall holder (not included in all versions) Mount the wall holder with plugs and screws to a smooth wall so that the standing surface for the Clean&Charge is horizontal. Only applies for cordless shavers: For the first charge of the shaver, connect the low voltage supply cord directly to the shaver, charge it for 4 hours and shave at least once. Only then can the shaver be cleaned or recharged in the Clean&Charge. If the rechargeable batteries are discharged, select the combined «clean» + «charge» programme rather than the «clean» programme alone. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. [. . . ] Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. [. . . ]