User manual BRAUN 760CC

[. . . ] Do not use this appliance with a damaged or broken foil, as serious skin injuries may occur. To disconnect, turn all controls to «off», then remove plug from outlet. When plugging to an electrical outlet outside the USA, use a plug adapter to match the outlet's pin configuration. Warning To prevent the cleaning fluid from leaking, ensure that the Clean&Renew station is placed on a flat surface. [. . . ] When fully charged both charge segments will light up continuously, provided the shaver is switched on or connected to an electrical outlet. The red low charge segment flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. Do not expose the shaver to temperatures higher than 122 °F / 50 °C for extended periods of time. The pivoting shaver head and floating foils automatically adjust to every contour of your face. Under the nose) slide the shaver head «lock» switch 0 to the back position to lock the pivoting head at an angle. Stretch your skin and shave against the direction of your beard growth. Shaving with the cord If the shaver has run out of power (discharged), and you do not have the time to recharge it in the Clean&Renew station, you may also shave with the shaver connected to an electrical outlet via the special cord set i. Automatic cleaning After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving». With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricates, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper. Manual cleaning The hand-held unit shall be detached from the power supply cord before cleaning. Rinsing the shaver head under running water is an alternative way to keep the shaver clean, especially when travelling: · Switch the shaver on (cordless) and rinse the shaver head under hot running water. Next, switch off w the shaver, press the release button 9 to remove the foil and cutter cassette 8 and let it dry. If you regularly clean the shaver under water, then once a week apply a drop of light machine oil on top of the foil and cutter cassette. Alternatively, you may clean the shaver using the brush provided: · Using the brush, clean the inner area of the pivoting head. However, do not clean the cassette with the brush as this may damage it. Cleaning the housing From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests. [. . . ] This warranty does not cover foil and cutter cassette or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. In the event a Braun Shaver fails to function within 2 years from date of purchase, because of defects in material or workmanship, and the consumer returns the unit to an authorized service center, Braun Canada, will, at its option, either repair or replace the unit without additional charge to the consumer. [. . . ]