User manual BRAUN 760 CC-4

[. . . ] This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are supervised by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Stand-by mode 10 minutes after completing the charging or cleaning session, the Clean&Renew station switches to the stand-by mode: The indicators of the Clean&Renew station turn off. During charging or when using the shaver, the respective green charge status will blink. When the battery is fully charged the green charge status will light up continously, provided the shaver is switched on or connected to an electrical outlet. Stand-by mode (Shaver is switched off but connected to the mains) Some minutes after completing the charging, the shaver switches to the stand-by-mode: The display turns off. Low charge indicator: The red low charge indicator blinks to indicate that the charge has dropped below 20%, provided the shaver is switched on. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. Personalizing your shaver With the (­) e and (+) r buttons you can choose the best setting for shaving different areas of your face and as per your specific needs. The different settings are indicated by the pilot light incorporated in the on/off switch w: White (for a thorough comfortable shave in sensitive areas of your face such as neck) For a thorough and fast shave we recommend the «+» setting. How to use Press the on/off switch w to operate the shaver: · The pivoting shaver head and floating foils automatically adjust to every contour of your face. Under the nose) slide the shaver head «lock» switch 0 to the back position to lock the pivoting head at an angle. Stretch your skin and shave against the direction of your beard growth. Shaving with the cord If the shaver has run out of power (discharged), and you do not have the time to recharge it in the Clean&Renew station, you may also shave with the shaver connected to an electrical outlet via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&Renew station and proceed as described above in the section «Before shaving». With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricants, which may leave residual marks on the outer foil frame after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper. [. . . ] The replacement symbol will remind you during the next 7 shaves to replace the Foil & Cutter cassette. After you have replaced the Foil & Cutter cassette, use a ball-pen to push the reset button t for at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. [. . . ]