User manual BRAUN 7526

[. . . ] Do not use this appliance with a damaged or broken foil, as serious facial injuries may occur. To disconnect, turn all controls to «off», then remove plug from outlet. Your Braun Syncro is supplied with a Braun Clean&RenewTM (please see section B). SmartLogic The «SmartLogic» electronics inside your shaver analyzes your personal shaving patterns, and then adapts the battery care and cleaning cycles to ensure optimal performance. [. . . ] Using the brush, clean the cutter block and the inner area of the pivoting head. About every four weeks, clean the cutter block with Braun cleaning agents. If your skin is very dry and you notice a reduced operation time of the shaver apply a drop of light machine oil onto the shaver foil. Replacing the shaving parts The shaver foil and cutter block are precision parts that, in time, are subject to wear. Replace your foil and cutter block every 18 months and get a 25 % better shave. 7000) (* Overall evaluation from Braun users comparing their shave with new parts and those used for 18 months. Available at your dealer or Braun Service Centres: Shaver foil and cutter block (part No. Nevertheless, in the interest of recycling raw materials, please do not dispose of this appliance in the household waste at the end of its useful life. disposal can take place at a Braun Service Center or appropriate collection sites. Braun Clean&RenewTM has been developed to automatically clean and charge your shaver. For peak performance of your shaver, clean it daily in the Clean&RenewTM. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid also contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of your shaver. important · Only use the power supply cord set supplied with the shaver. In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Be careful not to tip, move suddenly or transport in any way if a cleaning cartridge is installed. Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. Power consumption: 3 W when cleaning 7 W when charging · For the first charge of the shaver, connect the power supply cord set directly to the shaver, charge it for 4 hours and shave at least once. Only then can the shaver be cleaned or recharged in the Clean&RenewTM. If the rechargeable batteries are discharged, select the combined «clean + charge» program rather than the «clean» program alone. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. [. . . ] Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. In the event a Braun appliance fails to function within 2 years from date of purchase, because of defects in material or workmanship, and the consumer returns the unit to an authorized service center, Braun Canada, will, at its option, either repair or replace the unit without additional charge to the consumer. This guarantee does not cover any product, which has been damaged by dropping, tampering, wrong current, servicing performed or attempted by unauthorized service agencies, misuse or abuse, kinks in the shaver foil as well as the normal wear of the shearing parts. [. . . ]