User manual BRAUN 590 CC QUICK GUIDE

[. . . ] This appliance is not intended for use by children or persons with reduced physical or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. to prevent the cleaning fluid from leaking , ensure that the Clean&Renew station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. [. . . ] Shaving with the cord If the shaver has run out of power (discharged), you may also shave with the shaver connected to an electrical outlet via the special cord set. Cleaning indicator Clean your shaver in the Clean&Renew station at the latest when the yellow cleaning light (15) shines constantly after shaving. If this is not done, the cleaning light will go off after some time and the counter will be reset. Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs. The shaver head is in full swing, freely follows the contours of your skin to provide more comfort. After each shave, return the shaver to the Clean&Renew station and proceed as follows: · Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use. The shaver head is fixed for full control and precise handling in hard to reach areas. Long hair trimmer To trim sideburns, moustache or beard, slide the long hair trimmer (10) upwards. When cleaning is finished, the yellow cleaning light will go off and the shaver is ready for use. A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level indicator (1) has reached the «min» mark, the remaining fluid in the cartridge is sufficient for about 5 more cycles. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not daily used, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricates, which may leave residual marks on the shaver head after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper. Rinsing the shaver head under running water is an alternative way to keep the shaver clean, especially when traveling: · Switch the shaver on (cordless) and rinse the shaver head under hot running water. ⷠNext, switch off the shaver, press the foil release buttons (9) to remove the shaver foil (7) and cutter block (8). ⷠIf you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer (10) and shaver foil (7). The following quick cleaning is another alternative cleaning method: · Press the foil release buttons (9) to lift the shaver foil (do not remove the foil completely). However, do not clean the shaver foil nor the cutter block with the brush as this will damage them. [. . . ] This guarantee does not cover: damage due to improper use, normal wear and tear (e. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre. For UK only: This guarantee in no way affects your rights under statutory law. [. . . ]