User manual BRAUN 395CC-3

[. . . ] Charging lights (5) The green charging lights show the charge status of the batteries. The green charging light blinks when the shaver is being charged or switched on. When the battery is fully charged, all green charging lights shine permanently, provided the shaver is switched on or connected to an electrical outlet. Stand-by mode (shaver is switched off but connected to the mains) Some minutes after completing the charging, the shaver switches to the stand-by-mode: The display turns off. [. . . ] The replacement light will remind you during the next 7 shaves to replace the foil and cutter cassette. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. Cleaning indicator Your shaver should be cleaned daily in the Clean&RenewTM, and certainly when the yellow cleaning light (7) shines constantly after shaving. The shaver's electronics will then assume it has been cleaned manually and a new calculation of the time when the next cleaning is required will be started. During the cleaning process in the Clean&RenewTM the yellow light will flash and will go off after approx. Manual cleaning is recommended only when the Clean&RenewTM is not available, e. Manual cleaning The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water. Has to be fully discharged (by shaving) every 6 months approximately. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfils the lubrication needs of the shaver. important · Only use the power supply cord set supplied with the shaver. In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or lacquered surfaces. [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear and tear (e. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre (address information available online at www. [. . . ]