User manual BRAUN 390 CC

[. . . ] 1 2 3 4 5 6 7 8 9 10 11 Shaver foil protection cap Shaver foil Cutter block Release button On/off switch («start/stop») Long hair trimmer Charging light (green) Cleaning light (yellow) Replacement light for shaving parts Reset button Special cord set Turn on the shaver («start»): The pivoting cutting system automatically adjusts to every contour of your face. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. ⷠTo maintain 100% shaving performance, replace the shaver foil and cutter block, when the replacement light (9) comes on (after about 18 months), or when the shaving parts are worn. [. . . ] ⷠNext, switch off the shaver, remove the shaver foil and the cutter block. Alternatively, you may clean the shaver using the brush provided: · Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil. Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (9) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil (2) and cutter block (3): 31 S) The replacement light will remind you during the next 7 shaves to replace the shaving parts. After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (10) for at least 3 seconds to reset the display manually. While doing so, the replacement light blinks and goes off when the reset is complete. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver. important · Only use the power supply cord set supplied with the shaver. ⷠIn order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. ⷠDo not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. [. . . ] The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Clean the housing from time to time with a damp cloth, especially the opening where the shaver rests. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. [. . . ]