User manual BRAUN 350CC-3

[. . . ] ⷠ5-minute quick charge (with the special cord set (10)) is sufficient for a shave. ⷠIf the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set. Charging lights (5) The green charging lights show the charge status of the batteries. The green charging light blinks when the shaver is being charged or switched on. [. . . ] Replacement light for shaving parts/Reset (390cc only) To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. The replacement light will remind you during the next 7 shaves to replace the foil and cutter cassette. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. Model 350cc: To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), at least every 18 months or when worn. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Cleaning indicator Your shaver should be cleaned daily in the Clean&RenewTM, and certainly when the yellow cleaning light (7) shines constantly after shaving. The shaver's electronics will then assume it has been cleaned manually and a new calculation of the time when the next cleaning is required will be started. During the cleaning process in the Clean&RenewTM the yellow light will flash and will go off after approx. Manual cleaning is recommended only when the Clean&RenewTM is not available, e. Manual cleaning The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive 12 In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. [. . . ] When cleaning is finished, the yellow light will go off and the shaver is ready for use. ⷠA cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level indicator (4) has reached the «min» mark, the remaining fluid in the cartridge is Sufficient for about 5 more cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. [. . . ]