User manual BRAUN 350CC

[. . . ] The green charging light blinks when the shaver is being charged or switched on. When the battery is fully charged, all green charging lights shine permanently, provided the shaver is switched on or connected to an electrical outlet. Low-charge light (6) The red low-charge light flashes when the battery is running low. 1 Foil & Cutter cassette 2 Long hair trimmer 3 Precision setting switch («lock») (390cc/370cc only) 4 On/off switch 5 Charging lights (green) 6 Low-charge light (red) 7 Cleaning light (yellow) 8 Replacement light for shaving parts (390cc/370cc only) 9 Shaver power socket 10 Special cord set 11 Travel pouch (390cc/370cc only) 12 Foil protection cap (350cc only) The flexible shaving foils automatically adjust to every contour of your face (picture). [. . . ] Model 350cc: To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), at least every 18 months or when worn. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. Cleaning indicator Your shaver should be cleaned daily in the Clean&RenewTM, and certainly when the yellow cleaning light (7) shines constantly after shaving. The shaver's electronics will then assume it has been cleaned manually and a new calculation of the time when the next cleaning is required will be started. During the cleaning process in the Clean&RenewTM the yellow light will flash and will go off after approx. Manual cleaning is recommended only when the Clean&RenewTM is not available, e. Manual cleaning The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water. Rinsing the shaver head under running water after each shave is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection sites provided in your country. Replacing the cartridge After having pressed the lift button to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfils the lubrication needs of the shaver. important · Only use the power supply cord set supplied with the shaver. In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or lacquered surfaces. Connect your Clean&RenewTM with the cord set to the mains electricity supply. [. . . ] Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear and tear (e. [. . . ]