User manual BRANDT TI313

[. . . ] Programme guide 23 Washing programmes Programme Degree of soil and type of load Starting Require position of the push button programme selector Recommended quantity of detergent Cycle description Wash Prewash Normal 65°c with prewash Normal soil Crockery and cutlery A 65° + On/Off 25 g 5g Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Drying Main wash up to 65°C 1 cold rinse 1 hot rinse Drying Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying Main wash up to 50°C 1 cold rinse 1 hot rinse Drying Main wash up to 50°C 1 cold rinse 1 hot rinse 1 cold rinse (to avoid food scraps from sticking together). Normal 65°c no prewash Light soil Crockery and cutlery B 65° + On/Off 30 g / * Bio 50°c with prewash Bio 50°c no prewash Normal soil Crockery and cutlery A 50° + On/Off 50° + On/Off 25 g 5g Light soil Crockery and cutlery B 30 g / ** Quick wash 50°c Light soil Crockery and party crockery Any. Partial load (to be completed later in the day). C 50° + On/Off 30 g / Rinse & Hold D On/Off / / * Testing programme for EN 50242 (see "Hints for Test Centres"). ** This is a special programme for quick washing a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. 24 Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 9. [. . . ] At the end of the washing programme At the end of the programme the dishwasher will automatically stop. 2. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off push button and open the door. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 4. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. RC01 A When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. 27 Hints for test centres Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser Test standard: Reference programme: Load: Rinse aid selector: Detergent dosage: EN 50242 Bio 50°c with prewash 12 standard place settings position 5 25 g in the dispenser 5 g on the dispenser lid US57 UI49 UI72 Arrangement upper basket Arrangement lower basket Arrangement cutlery basket Technical specifications Dimensions Width Height Max depth Max depth with open door Voltage 59. 6 cm 81. 8 - 87. 8 cm 57. 5 cm 111. 4 cm 230 V - 50 Hz 200 W 2100 W 2300 W 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure Minimum Maximum Capacity 28 Protection against flooding In order to prevent water floods, the machine has been provided with two devices, having the following characteristics: 1. In the water inlet hose: The water supply hose is fitted with a safety device, which prevents water from entering the machine should the inner hose split, due to wear. It operates even with the machine off The problem is signalled by a red indicator which appears in the window (B - ). The retaining ring (A - ) must be properly fitted so as to avoid water leaks. Only for water supply hoses with Lock-fast safety device to prevent inadvertent loosening. To detach the hose press yellow lever (C - ) and turn the retaining ring anticlockwise . A 2 B A C B 1 CA13 2. In the bottom of the machine: This device will operate if there are any water leaks in the machine, however it will only operate if the machine is on. [. . . ] To detach the hose press yellow lever (C - ) and turn the retaining ring anticlockwise . A 2 B A C B 1 CA13 2. In the bottom of the machine: This device will operate if there are any water leaks in the machine, however it will only operate if the machine is on. In case of intervention, turn off the water tap and call the Service Force Centre. [. . . ]