User manual BRANDT GE2300B

[. . . ] It may only be used in a covered, enclosed and heated environment such as a kitchen or any other room meeting the same specifications. Its use in communal or professional premises such as rooms for breaks in offices or workshops, camping or hotel premises, does not represent compliant use as defined by the manufacturer. Install this oven adhering strictly to the installation instructions supplied with these instructions for use. Your machine is not intended to be put into operation using an external timer or a separate remote control system. [. . . ] At the end of its life this product must not be discarded with household waste. This makes it possible to avoid consequences resulting from inappropriate disposal that are harmful to health and the environment, and to recycle materials to save energy and significant resources. A logo appears on the product reminding you not to discard it with household waste. For further information, contact your council offices or the shop where you bought this product. Thus it is stamped with this logo to indicate to you that used appliances should be mixed with other waste. The recycling of appliances organised by your manufacturer will therefore be carried out in the best possible conditions, in compliance with the European directive in force concerning electrical and electronic equipment waste. Contact your Town Hall or your retailer to find out where the points for the collection of used machines nearest to your home are. Caution: Check that your machine has not been damaged during transport (door or seals distorted, etc. If you note any damage whatsoever before use, do not install the oven if it is damaged and contact your retailer. Control Panel: Remove the protective film from the surface of the control panel. Do not remove the light brown Mica coating which is found in the cavity of the oven and which protects the magnetron. Leave at least 30 cm of free space above the oven and 20 cm at the sides (Fig 1). Do not obstruct the air vents as you risk early damage to your machine. It is essential to use a socket with an earthing terminal connected in compliance with the safety standards in force. In your electrical installation provide a user-accessible device which must be able to separate the machine from the mains, the contact opening of which is at least 3 mm on all poles. If the power cable is damaged it must be replaced by the manufacturer, its after-sales service or any other similarly qualified person to avoid any danger. The electrical connection must be carried out before placing the machine in its final position. During maintenance operations the machine must be unplugged from the mains and the fuses must be cut off or removed. The machine must be connected with a standardised power cable with three 1. 5 mm² conductors (1 live + 1 neutral + 1 earth) which must be connected to the 220-240V 50Hz single phase mains with a standardised electric socket CEI 60083 fitted with two pins and one earth in compliance with the installation rules in force. The Earth wire (green/yellow) is connected to the machine's terminal and must be connected to the earth of your electrical installation. The Live wire (red, black, or brown) must be connected to the mains live. [. . . ] If you remove the turning gear, do not let water penetrate into the motor axle hole. Don't forget to return the turning gear, wheel guide and turntable. If you have doubts about the proper functioning of your appliance, this does not necessarily mean it is broken. In any event, check the following items: The appliance does not start. [. . . ]