User manual BRANDT BST524SW

[. . . ] Z Do not use any mechanical or other means, other than those recommended by the manufacturer, to speed up thedefrosting process. Z Do not use any electricappliances inside thecompartment for food, unlessthey are of a typerecommended by themanufacturer. Z Do not store any explosive substances, suchas aerosols containinginflammable propellant gases, inside the appliance. Z For models fitted with awater dispenser or an icecompartment, only fill orconnect using a supply ofdrinking water. [. . . ] eNERGY-SAVING MEASURES In order to reduce the power consumption of your appliance: , QVWDOOLWLQDVXLWDEOH ORFDWLRQVHH, QVWDOOLQJ \RXUDSSOLDQFH /HDYHWKHGRRUV RSHQIRUWKHVKRUWHVWWLPH SRVVLEOH 1HYHUSXWKRWIRRG LQWKHIULGJHRUWKHIUHH]HU DQGLQSDUWLFXODUVRXSVDQG RWKHUSUHSDUDWLRQVWKDW UHOHDVHDORWRIVWHDP Check that your appliance isworking correctly and do notallow too much ice to accumulate in the freezer (defrost when the ice is morethan 5-6 mm thick). Clean thecondenser on a regular basis (see chapter "Routine maintenance of your appliance"). Regularly check the door seals and make sure that thedoors can be closed properly. Failure to install the draws, ELQV and shelves properly can UHVXOWin increased power consumption. If your transported the appliance KRUL]RQWDOO\ position it vertically DQGZDLW for 2 hours before FRQQHFWLQJit. allow HQRXJKtime for the oil to return to WKHmotor before connecting the appliance, failing which, it could be Always unplug your appliance before any maintenance work. You should rest the unit on Something solid so that it will not slip during the door reversing process. Unscrew top hinge and then remove door and place it on a soft pad to avoid scratch. Then remove the adjustable feet from Note: remove this screw if it presents both side. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it. Ensure the door is aligned horizontally and vertically, so that the seals are closed on all sides before finally tightening the top hinge. levelling the unit To do this adjust the two levelling feet at front of the unit. If the unit is not level, the doors and magnetic seal alignments will not be covered properly. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm. Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate leveling is ensured by one or more adjustable feet at the base of the cabinet. It must be possible to disconnect the appliance from the mains power supply; the SOXJPXVWµWKHUHIRUHEHHDVLO\DFFHVVLEOH after installation. electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not observed. [. . . ] X Clean the appliance and the interior accessories with a cloth and lukewarm water. defrosting of the freezer The freezer compartment, however, will become progressively covered with frost. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as fellows: x pull out the plug from the socket; x remove all stored food, wrap it in several layers of newspaper and put it in a cool place; x keep the door open, and placing a basin underneath of the appliance to collect the defrost water; x when defrosting is completed, dry the interior thoroughly x replace the plug in the power socket to run the appliance again. [. . . ]