User manual BRANDT BIL2212SW

[. . . ] Installation must be according to the instructions in this manual; poor installation can damage the appliance. For potential operating problems of the appliance, always contact only the authorised customer care After Sales Service or qualified personnel. For all servicing, first disconnect the apparatus avoiding pulling on the power cable. If this refrigerator replaces another, that uses a latch closure, spring, lock or other, do not forget to destroy the closing mechanism or, better still, remove the door of your old appliance in order to prevent anyone from becoming trapped inside it (playing children, animals, etc). [. . . ] Consult your local authority or your retailer to find the drop-off points for used appliances that is nearest to your home. Clean the interior of the refrigerator with lukewarm water with some bicarbonate added. Wait 2 hours before turning it on to ensure the stabiliity of compressor-motor lubrication. It is possible to reverse the direction in which the door opens: The appliance must always be disconnected before Lean the appliance back gently and secure it in this position. Unscrew the upper hinge (A) and lower hinge (B), then pull off the door. Position the upper plastic guide, then screw the upper hinge into the top of the door. It is also possible to reverse the direction in which the freezer compartment door opens. Pull back the removable hinge with the help of a screwdriver and remove the door. Insert the removable hinge in the the lower shaft of the door, then clip it into the corresponding hole. Size of the space For safety reasons, ventilation must be provided as indicated in the diagram opposite. It is also necessary that the space Has a ventilation opening with the Insert the compressible gasket between the appliance and the furniture. Insert the caps (C-D) on the fin stops and in the holes of the hinges. Depending on the model, apply the ventilation grill (B) and the hinge cover. Insert the appliance into the space against the internal partition, corresponding to the hinging side of the door, so the upper cover cap is just proud (1) and the bottom hinge is aligned with the partition of the furniture (2). Fix the appliance in place with the 6 screws provided for this purpose. Place the runners (Ha) on the internal part of the furniture support and mark the position of the external holes. (continued) Open the door of the appliance and of the furniture about 90°. Hold appliance and furniture doors together and mark the position of the holes as shown in the drawing. Remove the bracket and make holes 8 mm from the outer edge of the door using a drill fitted with a 2 mm drill bit. Put the bracket back on the runner and fix it with the 8 screws provided. Use the set of oval holes to align the door of the furniture if necessary. At the end, it is necessary to check that the door of the appliance can shut perfectly. [. . . ] Check the position of the thermostat and adjust it to a better temperature. The refrigerator bulb does not light up If the problem persists, check that your appliance is properly connected to the power. This is normal, the compressor restarts after a certain length of time. If you have already made the indicated checks and your problem persists, DO NOT DO ANY REPAIRS YOURSELF. [. . . ]