User manual BRANDT AD769BE1

[. . . ] Please become familiar with these recommendations before installing and using your oven. € SAFETY RECOMMENDATIONS — This oven was designed for use by private persons in their homes. Make sure that children do not touch and that they do not treat it as a toy. € When you receive the appliance, unpack or have it unpacked immediately. [. . . ] It is marked with this label to indicate that in countries that are a members of the European Union the used appliances should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. warning Installation should only be performed by installers and qualified technicians. Warning Remove the protective film from the cartridge filter before use. Qxp 11/12/2006 16:19 Page 39 2 / INSTALLING YOUR APPLIANCE EN - The appliance must be unplugged during installation or when any repairs or maintenance work is being performed. - Ensure that the network voltage corresponds to the voltage noted on the identification plate located inside the hood. - If the electrical installation at your residence requires any changes in order to hook up your Appliance, call upon a professional electrician. - If the hood is being used in evacuation mode, do not connect the appliance to a combustion gas exhaust duct (boiler, chimney, etc. - Under no circumstances should the exhaust duct empty into the attic. - Install the hood at a safe distance of at least 70 cm from an electric, gas or combined cooking hob. 2 Tip Adjust the level of your hood before fully tightening up the four D and E screws. 1), attach the metal chimney bracket against the wall, flush with the ceiling for support. This back-flow valve makes it possible to block the entry of air from the outside. € If a 125 mm flue is being installed, use the adapter provided (fig. If the diameter of your exterior flue is less than 125 mm, you must connect your hood in recycling mode. € Prepare your telescoping ventilation shaft, taking care not to block the vents (fig. € Adjust the length of the telescoping chimney by bringing down the lower part and fitting it into the top of the hood. 2), attach the plastic smoke deflector against the wall, flush with the ceiling for support. € Slide one end of the flue over the deflector and the other end over the motor outlet (fig. € Prepare your ventilation shaft, taking care to face the vents upward so that they are visible (B/fig. € Adjust the length of the telescoping chimney by bringing down the lower part and fitting it into the top of the hood. [. . . ] Commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. This component plays an important role in ensuring the effectiveness of your hood. In the event of tough stains, use a non-abrasive cream, then rinse with clean water. This filter traps odours and must be changed at least once a year depending on your level of use. [. . . ]