User manual BRANDT AD1189X

[. . . ] -- Provide adequate ventilation for the room in the case of simultaneous use of the hood and other appliances powered by an energy source other than electricity. -- You should never "flambé" dishes under the hood or operate gas rings under the hood without placing cookware on them (the flames sucked up into the hood can damage the appliance). -- When frying food under the appliance, You must carefully monitor the preparation at all times. -- Respect the recommended frequency of cleanings and filter replacements. [. . . ] It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. Fixing to the wall : -- Mark a vertical line on the wall centred on the cooktop. -- Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance. -- Drill the three 8 mm diameter holes in a suitable position and insert the plugs (part A Pic. -- Before fixing the hood, mount the nonreturn valve on the motor outlet -Secure the hood's fixing support, ensuring that it is perfectly level. 1) -- Fix the extendable evacuation sleeve (not included) to the motor outlet without impeding the movement of the non-return valve. -- Fit and secure the body of the hood on this support with the screws provided for this purpose. -- Calculate the final height for fixing the duct support U-bracket (part B Pic. -- Drill 8 mm diameter holes and secure the duct support bracket, ensuring that it is fixed on the same axis as the hood (part B Pic. Slide the glass in and secure it with the 4 screws with rubber seal (glass safety). -- Make the electrical connection to the hood using the mains supply cable. -- Lift the upper duct up to the ceiling and fix it to the bracket using the screws. -- Calculate the final height for fixing the duct support U-bracket (part B Pic. [. . . ] - Bruk aldri damp- eller høytrykksenheter for å rengjøre apparatet (krav for elektrisk sikkerhet). - For å stadig forbedre våre produkter , forbeholder vi oss retten til å endre tekniske , funksjonelle eller estetiske egenskaper ved apparatet , gjøre eventuelle endringer i dets funksjoner hvis det anses som nødvendig eller ønskelig i henhold til tekniske fremskritt. - For å enkelt finne referansen for enheten din, an befaler vi at du noterer deg denne informasjonen på siden for "etterkjøps-service". Kontakt rådhuset eller forhandleren for innsamlingspunkt for brukte apparater nærmest ditt hjem. [. . . ]