User manual BRANDT AD1188X

[. . . ] € You should never “flambé” dishes under the hood or operate gas rings under the hood without placing cookware on them (the flames sucked up into the hood can damage the appliance). € When frying food under the appliance, you must carefully monitor the preparation at all times. — Respect the recommended frequency of cleanings and filter replacements. € The hood should never be used over a combustible fuel burning stove (wood, coal, etc. [. . . ] Suitable ventilation should be provided in the room when the hood is used at the same time as appliances operated by gas or another combustible fuel. 4 1 / NOTICES TO THE USER • ENVIRONMENTAL PROTECTION EN — This appliance’s packaging material is recyclable. Help recycle it and protect the environment by dropping it off in the municipal receptacles provided for this purpose. — Your appliance also contains a great amount of recyclable material. It is marked with this label to indicate the used appliances that should not be mixed with other waste. This way, the appliance recycling organised by your manufacturer will be done under the best possible conditions, in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment. Contact your town hall or your retailer for the used appliance collection points closest to your home. warning Installation should only be performed by installers and qualified technicians. Warning Remove the protective film from the cartridge filter before use. 5 EN 1 / NOTICES TO THE USER • DESCRIPTION OF YOUR APPLIANCE 6 2 / INSTALLING YOUR APPLIANCE • ENVIRONMENTAL COOKER HOOD • INSTALLING YOURPROTECTION — The ceiling must can bear at least 40kgs weight, and the thickness of the ceiling must be 30MM, see pic 2, drill 1*170mm round hole in the ceiling. EN — According to the hanging board, drill 12 holes in the ceiling, see pic 2, 12pcs of ST6*40mm big flat screws will be used to fix the hanging board on the ceiling, and then 8pcs of M4*10 screws and M4 nut with gasket will be used to connect the angle iron into the hanging board, see pic 1, calculated the length of the angle iron, and 16pcs M4*10 big flat screws and M4 nut with gasket will be used to connect the angle iron and another angle iron ( the overlap length of angle iron can not less 100MM) Pic 1 Pic 2 — Let the one side of the extensible pipe go outside through the hole of 170MM, see pic 3. € INSTALL THE T-SHARP OUTELT — Fix the outlet outlet on the T-sharp, see Pic 15. Pic 15 Pic 16 10 4 / CARING FOR AND CLEANING YOUR APPLIANCE Warning EN Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch. • MAINTAINING YOUR APPLIANCE MAINTENANCE WHAT TO DO Never use metal scouring pads , abrasive products or excessively stiff brushes. Top surface and accessories PRODUCTS / ACCESSORIES TO USE To clean the body and the lighting port, you should use only commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. Use a commercial household cleaning product then rinse abundantly and dry. These filters can be cleaned in a vertical position in your dishwasher. This component plays an important role in ensuring the effectiveness of your hood. In the event of tough stains, use a nonabrasive cream, then rinse with clean water. Activated carbon filter This filter traps odours and must be changed at least once a year depending on your level of use. You should order these filters from your dealer (quoting the reference shown on the identification plate located inside the hood) and note the date the filter was changed. To preserve your appliance, we recommend that you use Clearit cleaning products. [. . . ] € The kitchen is sufficiently ventilated to allow for fresh air intake. • The carbon filter is not worn (hood operating in recycling mode). The hood stopped working • The single-pole cut-off device was not activated. EN 6 / AFTER-SALES SERVICE Any maintenance on your equipment should be undertaken by: - either your dealer, - or another qualified mechanic who is an authorized agent for the brand appliances. [. . . ]