User manual BOWENS HOTLITE BROCHURE

[. . . ] SPECIFICATIONS Models (230V) 1000W 500W 300W BW3560 BW3561 BW3562 Supply Voltage 220V - 240V 50/60Hz Fuse (230V) 6. 3 Amp (F) 20mm HRC Lamp 240V 1000W CP77 240V 500W CP77 240V 500W CP77 240V 300W CP77 BW3555 (1000W Lamp) BW3564 (500W Lamp) BW3565 (300W Lamp) BW3568 (300W Lamp) Cover Dome Internal Fan UV coated 1000W 500W 300W Yes Yes No Dimensions 1000W - 120mm dia. Stand Bracket or handle) Weight 1000W 500W 300W - 1. 2Kg 1. 2Kg 1. 0Kg Cable Length 5. 0m HOTLITE USER GUIDE BWL-0385/1 (07/07) BOWENS INTERNATIONAL LIMITED 355 Old Road Clacton On Sea Essex CO15 3RH Tel: +44 (0)1255 422807 Fax: +44 (0)1255 436342 www. bowens. co. uk OPERATING INSTRUCTIONS Introduction Dear Valued Customer, Welcome to the world-wide family of Bowens equipment users, and congratulations on selecting the Hot-Lite. [. . . ] Do not use in this condition, return for repair immediately. · Halogen lamp (recommended Halogen bulb - CP77, with G9. 5 base). · Clear uncoated cover glass provides; protection in the event of lamp failure. · Low noise cooling fan (not all models - see specifications for details). · Lamp On/Off switch fitted on rear moulding · Adjustable stand bracket. · Bowens `S' type accessory adaptor. Reflector/Accessory System The unit comes fitted with a fixed reflector attached to the body with four thumbscrews. An `S' Type adaptor is available which is compatible with all Bowens accessories/reflectors. Safety Notes · The Hot-Lite must not be used in an environment where moisture or flammable vapour is likely to come in contact wit the unit. A fire hazard exists if flammable materials are placed in close proximity to the lamp when in use. · Do not onstruct the airflow around the unit and keep all vents clear at all times. · Disconnect from mains and allow to cool before fitting/removing accessories or changing fuse/lamp. · A 20mm fuse mounted on rear panel provides circuit protection for the lamp. Damaged cables must be replaced immediately. Lamp Replacement Before atempting to replace the lamp, switch off the unit and unplug from the mains. Remove the glass dome by pulling it straight off over the spring clips, do not twist. [. . . ] Only use lamps as recommended in the specifications (See reverse of user guide for specs). 3. Operation Select a stand or support system weight and dimensions to ensue stable operation of the unit. The angle of the head may be set using the locking handle, always support the unit before releasing the handle and never force adjustment without releasing the handle. 2. [. . . ]