User manual BOSTON ACOUSTICS VSI 570

[. . . ] Always turn off the amplifier or receiver when connecting speakers or any other components to the system. This manual assumes the installer possesses skill in the proper use of hand and power tools, knowledge of local building and fire codes, and a familiarity with the environment behind the wall or ceiling in which the speakers will be installed. Given the intelligent engineering inside, a VSi system will make its presence known to any set of critical ears in the room. Our VSi systems are direct descendants of our highly acclaimed Boston Reference speaker systems. [. . . ] ⷠSee the Boundary Compensation section if the speakers are mounted closer than 24-inches to an adjacent wall. Behind the mounting surface, there must be 1-inch (25mm) clearance around the mounting hole. Performance of your VSi loudspeaker can be enhanced if the ceiling cavity is filled with standard fiberglass insulation. If there is already insulation in the wall that has a paper backing facing the speaker, remove the backing in the area behind the installation location. ) Taking steps to increase the rigidity of the mounting surface by using additional drywall screws, and/or the use of a construction adhesive between the drywall and joists adjacent to the speaker location, will further enhance performance. If you are using your VSi loudspeakers with a surround sound processor and subwoofer, set the bass management control to "Large. If the VSi loudspeakers are installed in a damp location (kitchen, bathroom), they should be positioned so that moisture cannot collect inside them. The VSi speakers are NOT for use in locations where they will be submerged. For new construction installations, we offer new construction brackets. The response of a speaker changes when it is mounted close to the boundary junctions of a room (near an adjacent wall or close to the corners of the room). Your Boston VSi loudspeakers have been carefully voiced to compensate for these boundary effects. The speaker is mounted less than 18-inches (46cm) from the junction of two surfaces (wall/ceiling). The speaker is mounted less than 24-inches (61cm) from the junction of three surfaces (a room corner). Less than 24"/61cm ­ Boundary Compensation ON More than 24"/61cm ­ Boundary Compensation OFF Less than 18"/46cm ­ Boundary Compensation ON More than 18"/46cm ­ Boundary Compensation OFF Always turn off the amplifier or receiver when connecting speakers or any other components to the system. This manual assumes the installer possesses skill in the proper use of hand and power tools, knowledge of local building and fire codes, and a familiarity with the environment behind the wall or ceiling in which the speakers will be installed. A utility knife, jig saw, or other tool for cutting the required hole in the mounting surface. Insert a long, bent piece of wire and rotate to confirm that there are no obstructions behind the chosen location. The VSi speaker jack will accept either bare wire up to 12-gauge, or single banana plugs. The mounting arms will pivot into position and clamp the speaker to the mounting surface. If you wish to paint your speakers or grilles, it should be done prior to installation of the grille. [. . . ] Excluded from this warranty is damage that results from abuse, misuse, improper installation, accidents, shipping, or repairs/ modifications by anyone other than an authorized Boston Acoustics service representative. This warranty is limited to the Boston Acoustics product and does not cover damage to any associated equipment. This warranty is void if the serial number has been removed or defaced. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. [. . . ]