User manual BOSTON ACOUSTICS SOUNDWARE XS 5.1

[. . . ] Maintain a minimum distance of 2" (50mm) around the front, rear, and sides of the apparatus for sufficient ventilation. The ventilation should not be impeded by covering the ventilation openings or placing on or around the apparatus items such as newspapers, table-cloths, curtains, etc. No objects filled with liquids, such as vases, shall be placed on the apparatus. Either the power inlet connector on the rear of the apparatus or the power plug at the wall must remain accessible, to be able to disconnect power from the apparatus. [. . . ] 1 Put the rounded end of the speaker mount in the bracket and slide it down to lock it in place. Vertically they can go from facing straight out to being tilted down 40 degrees. When the flat wall mounting bracket is used they can pivot side to side 20 degrees. (Note: Corner mounting will not allow the speaker to pivot side-to-side. ) Loosen the pivot set screw on the front of the pivoting ball mount, pivot the speaker into position and retighten the screw. The SoundWare speakers can also be mounted using the supplied corner bracket. Pivots down 40° pivots 20° each way NOTE: Power is always supplied to the subwoofer electronics unless it is unplugged or switched to the off position using the power switch located on the rear panel. The auto-on circuitry only activates or deactivates the power amplifier. Make sure your subwoofer and receiver are unplugged when making the connection. Power: When plugging your subwoofer in be sure to use a wall outlet, or dedicated electrical outlet. These on board electrical outlets do not offer the amount of current or proper isolation required by a power amplifier, such as the one in your amplifier. select "subwoofer-yes" from your receiver's set-up menu. If the receiver gives a choice of crossover filter frequency, use 150Hz or 120Hz. Hooked up this way, the receiver's amplifier is relieved of having to reproduce the difficult low bass signals that can drive the receiver into audible distortion. In some cases, it can also depend on several other settings within a receiver. We recommend consulting your receiver manual for further assistance in this area. Use a subwoofer cable, as shown, to connect your digital receiver's LFE subwoofer output to the subwoofer. Fine-tune the crossover setting by ear for the smoothest blend with your main speakers. You may want to turn your subwoofer off if you will not be using it for some time or wish to conserve electricity. MUTE ­ If no signal is detected after several minutes, it will automatically enter the Mute mode. An LED indicator between the Power switch and the Polarity switch indicates what mode the subwoofer is in. OFF ­ The subwoofer is off RED ­ MUTE (No signal detected, Audio Off ) gREEN ­ ON (Signal detected, Amp On) The subwoofer will automatically enter the Mute mode after several minutes when no signal is detected from your system. [. . . ] Si vous désirez utiliser le support de montage, vous devez fixer le support à rotule pivotante au haut-parleur. 1 Placez l'extrémité arrondie du support du haut-parleur dans le support mural et faites-le glisser pour le bloquer en place. Använd markeringen på högtalarkablarna för att vara säker på att förstärkarterminalen "+" ansluts till högtalarens terminal "+" och att "-" alltid ansluts till "-" vid varje anslutning. OBS: Strömmen går alltid till subwoofern såvida den inte är frånkopplad eller ändras till lägeoff med strömbrytaren som finns på den bakre panelen. [. . . ]