User manual BOSTON ACOUSTICS BRAVO II CENTER

[. . . ] Its built-in, height adjustable rear stand allows it to be safely placed on top of any type of television set regardless how wide the top surface is or how much it angles. Setting up the Bravo II Center on any television set is as simple as loosening the thumbwheel on the adjustable rear stand and then sliding the rear leg up or down to accommodate the top surface of your television. [. . . ] This will divert very low frequencies away from the center channel to the main speakers and/or subwoofer. left front center right front surround sound receiver/amplifier 3 Mounting/Installing the Bravo II Center The Bravo II Center can be configured to accommodate any style of television and home theater arrangement. Take a minute to study the type of television that you have in order to determine which of the following configurations you should use. Flat Top Placement This is the simplest way to configure the speaker and should be used wherever possible. If you are placing the Bravo II Center on top of a rear projection TV or one with a large flat top surface (six inches or more in depth), then you can use it just the way it comes out of the box. Use the four self-adhesive rubber feet (provided) to protect the TV's finish and reduce vibration. Peel off and apply a foot to each semi-circular pad located underneath the two front corners of the housing as shown. Apply the other two feet to the outerself-adhesive feet most corners of the rear support section on either side of the rotating mounting pad as shown. Alternatively, you may wish to secure the speaker to its surface by eliminating the rear feet and using the self-adhesive, pre-installed hook-and-loop strip instead (see illustration below). Angled Top Placement If your TV has a shallow top (less than six inches in depth) and angles downward in the back, then you should use the sliding rear stand to secure the back half of the speaker. First apply the two front rubber feet as shown above (do not apply the rear feet). Loosen the knurled knob, move the slide down and flip up the rotating mounting pad. With the speaker centered and in the position that you want it to stay in, move the slide down until the mounting pad contacts the angled surface of the TV. Pull off 1 1/2'' (38mm) max rotating mounting pad pre-installed self-adhesive strip paper backing the paper backing from the pre-attached, self-adhesive hook-and-loop strip and stick the mounting pad on the TV. Press down on the mounting pad to ensure that the two hook-and-loop halves are locked. [. . . ] If it is necessary to return your speaker to the factory, please ship it prepaid. After it has been repaired, we will return it freight prepaid in the U. S. A. [. . . ]