User manual BOSS RV-3

[. . . ] This helps avoid the potential effects of incorrect disposal on the environment and human health. This will contribute to the recycling and other forms of reutilization of electrical and electronic equipment. Information concerning where the equipment can be disposed of can be obtained from your local authority. SPECIFICATION GENERAL Supply Voltage Current Consumption Power Output Number of channels Unit Dimensions FM SECTION Frequency range Effective sensitivity I. F Frequency AM SECTION Frequency range Effective sensitivity I. F Frequency RCA LINE OUT Output CD PLAYER System Suitable CDs Frequency characteristics S/N Ratio to CD DC 12 V. Negative Ground Max. 10A 80Watts X 4 (Measured at DC 14. 4 V) 2 STEREO channels. [. . . ] When turning on the LOUD mode, it will enhance bass level immediately when the bass is not enough. To display and adjust the clock time A) Time display Press the CLOCK button shortly to display time for 5 seconds, and then it returns to its previous display unless the button is pressed again. B) Time adjustment From the clock mode, press the CLOCK button and hold for more than 1 seconds to flash time and then rotate the VOL knob clockwise to adjust minute, rotate the VOL knob counter clockwise to adjust hour. To select and adjust the mode of the sound and menu A) To select and adjust the sound mode: Press SEL button briefly and repeatedly to select the mode of VOL(volume), BAS (BASS)(without preset DSP), TRE(treble)(without preset DSP), BAL(balance) and FAD(FADER) in the sequence and circulation. In each mode, the waiting time is about 5 seconds, and when the waiting time is over, it will return to the the last display mode. After select a desired sound item, rotate the VOL knob on the front panel or press the + or - button on the remote controller to adjust level of the selected sound item. Page 3 Page 12 CARE FOR USING CD'S: About CD-R/CD-R/W discs: In addition to commercially-recorded audio CD's, this unit can play CD-R and CD-R/W discs. In come cases, particularly when recorded on older CD burners, some CD-R and CD-R/W discs may not play. Also, whenever you are recording a CD for playback in this receiver, it is recommended that you record at 24x or slower speed for CD-R and 4x or slower for CD-R/W to achieve higher signal quality and better playback performance. To keep the disc clean: Do not attach any sticker or adhesive tape on the disc. Handle the disc by its edge to keep the disc clean and do not touch the surface. Before playing a disc, wipe it off with a clean, dust-free cleaning cloth. Do not expose the disc to direct sunlight or nearby heat sources such as heating vents, caliduct which can cause the disc to warp. To select the radio station manually or automatically Under RADIO mode, short press the >>| or |<< button repeatedly to manually tune up or down for the desired radio station step by step. Long press the >>|/ |<< button to automatically tune up or down for the radio station of strong signal. To store the current station or turn on the preset station A) Press one of 1-6 number buttons hold for more than 1 second until the second beep output to store the current station in the preset memory bank of the number button for the current band. B) Press one of 1-6 number buttons shortly to turn on the preset station stored in the preset memory bank of the number button for the current band. Removing the tag from the remote before using. B) In FM mode, when the signal of the local radio station are too strong to lead that the interference to the receiving effect during tuning, press this button to turn on the LOC function to display the word LOC on LCD, then tune again for the local radio station. USB or DISC OPERATION: 1. To load/unload disc Press the REL button to flip down the front panel and then insert the disc into the disc compartment or press the EJ button to eject the disc from the disc compartment. To load/unload USB storage Insert the USB storage into USB socket, then the playing mode will be changed into USB mode and display USB on LCD, and then play the first track of USB. NOTE: Always remember to switch off the unit's power or switch to other mode then remove out the USB Stick. Never try removing the USB Stick while playing music file on the USB stick. It may damage the USB stick and sometimes will caused the unit system lock up. To select next or previous track to play Under USB or DISC mode, press the >>| button to select next track to play. [. . . ] Then rotate the VOL knob on the front panel or hold the + or - button on the remote controller to select the number of the flashing digit from 0 ~ 9. Then press SEL button to confirm the number and flash next smaller digit 0. After finishing selecting the number of all flashing digit, press SEL button to play the track of the selected serial number. B) Under DIRECTORY SEARCH mode , the LCD will display the root folder(if there is not the root folder, it will find a root folder named ROOT). [. . . ]