User manual BOSS RDS740UA

[. . . ] Please read this manual carefully before operating this car audio product. It will be helpful to you if you are encounter any operational problem. Selecting fine audio equipment is only the start of your musical enjoyment. Now it is time to consider how to maximize the enjoyment you will get from knowing how to work your new car stereo receiver. [. . . ] To take away the front panel Press the REL button to flip down the front panel and then take it away from the head unit. And the anti-theft LED indicator will flash all the time till the front panel is assembled back to the head unit. ÒÉÑâý CAREÄ ½ ³ CD'S: FOR USING About CD-R/CD-R/W discs: In addition to commercially-recorded audio CD's, this unit can play CD-R and CD-R/W discs. In come cases, particularly when recorded on older CD burners, some CD-R and CD-R/W discs may not play. Also, whenever you are recording a CD for playback in this receiver, it is recommended that you record at 24x or slower speed for CD-R and 4x or slower for CD-R/W to achieve higher signal quality and better playback performance. RADIO OPERATION: 1. To select radio band In RADIO mode, press the BAND button shortly and repeatedly to select your desired radio band in sequence and circulation as follows: -->FM1-->FM2-->FM3--> 2. To select the radio station manually or automatically Under RADIO mode, short press >>| or |<< button and repeatedly to manually tune up or down for the desired radio station step by step. Long press >>| or |<< button to automatically tune up or down for the radio station of strong signal. To store the current station or turn on the preset station In RADIO mode: A) Press one of 1-6 number buttons and hold for more than 1 second until the second beep output to store the current station in the preset memory bank of the number button for the current band. B) Press one of 1-6 number buttons shortly to turn on the preset station stored in the preset memory bank of the number button for the current band. In case of RDS mode, the strongest AF is turned on after AF searching. Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna according to the requirements of this Instruction Manual, then install the metal mounting sleeve into the car as per the diagram illustrated below. METAL SUPPORT STRAP To boost up the capability of anti-jamming, please make sure fix tightly the metal support strap into the metal joint that connect to the chassis of the car. To properly fix the meal mounting sleeve, bend the tabs of the sleeve against the DASHBOARD with a screwdriver. 5. To scan for strong signal of radio station Press the SCAN button to scan the radio frequency. If a valid signal has been detected, the current frequency will hold and blink for 5 seconds. Press this button again within 5 seconds to stop scanning and confirm the current desired frequency, otherwise the radio will revert to scanning for other radio frequencies. To tune for RDS station Press PTY button shortly and repeatedly to select one of the following mode: PTY MUSIC group- - PTY SPEECH group- - PTY OFF While selecting PTY TYPE, its selection is implemented by preset buttons (press one of the 6 preset buttons shortly and repeatedly to select the PTY TYPE in the preset button) as follows: PTY music group ------------------PTY speech group --------------- OFF 1. TRAVEL, LEISURE, DOCUMENT When PTY MUSIC or PTY SPEECH is on, the previous PTY program and PTY word is displayed on LCD. If there are no keys entered for 2 seconds, previously selected PTY is searched. During 1 loop, if desired PTY is not found, NO PTY is flashed, then return to previous normal radio and PTY word disappear. To alternate the weak signal of RDS station with a strong one When pressing the AF button briefly, AF switching mode is selected and the state of AF switching mode is displayed by AF segment in display. Segment flashing: AF switching mode on, but RDS information is not received yet. When AF switching mode is selected, the radio checks the signal strength of AF all the time. [. . . ] Under CD/MP3/WMA disc mode, press RPT button shortly to display S-RPT and play the current track repeatedly. Under USB or MP3/WMA disc mode, press RPT button long to display D-RPT and play the current folder repeatedly. To play tracks in random Under USB mode, press RDM button shortly to display M-RDM and play the track of all in random order. Under CD/MP3/WMA disc mode, press RDM button shortly to display S-RDM and play the tracks of all in random order. [. . . ]