User manual BOSS RDS534UA

[. . . ] Ink is sticky (P . 5). ******* **** ******* ******* ******* P1 . Do not stick paper or tape on the disc (P P5 . Do not use rental CDs with old labels that are beginning to peel off. Stickers that are beginning to peel away, leaving a sticky residue (P . 6). Do not expose the discs to direct sunlight or heat sources such as hot air-ducts, or leave them in a car parked in direct sunlight where there can be a considerable rise in temperature inside the car (P . 3). Do not use your CDs with labels or stickers attached. Labels are attached (P . 7). ******* ******* ******* ******* ******* P7 . Do Not Use Special Shape CDs Be sure to use round shape CDs only for this unit and do not use any special shape CDs. [. . . ] 18) FRONT (AND REAR PANEL) AUXILIARY INPUT JACKS This unit features AUX IN line input jacks on both the front (headphone type) and rear (RCA type) panels. PLEASE NOTE: AUX IN JACK IN PANEL These two inputs cannot be used simultaneously. If you have a source unit plugged into the rear panel jack and wish to listen to a portable device (such as an MP3 player) by using the front panel jack, be sure to power off the unit plugged into the rear unit to Left Audio avoid interference. Right Audio Ground Similarly, if you have a device plugged into the front panel jack and wish to listen to the unit plugged into 3. 5mm Audio In Cable (not included) the rear panel, be sure to turn off the front panel device. To select either the front or rear AUX IN device as a listening source, press the SOURCE button to select AUX mode. To cancel AUX IN listening, press SOURCE again. 1 2 3 RESET BUTTON The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons: Initial installation of the unit when all wiring is completed. Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. E-7 7. AUDIO OPERATIONS 10) VOLUME KNOB Turn this knob to adjust desired volume level. 4) AUDIO BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. - If the volume level was under the threshold point, it will be raised to the threshold point. - When TP station is received, TP segment is turned on in LCD display. When pressed for couple of seconds, EON TA LOCAL /EON TA DISTANCE mode is selected. - EON TA LOCAL mode When the field strength level of EON linked is less than the threshold level. The radio does not switch that station and user can hardly listen to any disturbances. - CT (Clock Time) This function permits to update the clock of the receiver the nation from which the station is broadcasting (from PI). It could happen that on the display will be shown the wrong hour; this happens because in Italy the Clock Time function is not working yet. Notes Depending on the country or region, not all of the RDS functions are available in Italy. RDS may not work properly if the signal strength is weak or if the station you are tuned to is not transmitting RDS data. PROGRAMMABLE OPTIONALS To use this function press SEL Button for few seconds, each time you press this button the mode will move and the functions will shown on the display, turn the volume knob to set the desires functions , the function states as following: - TA SEEK, TA ALARM To determine what action will the radio take if the newly tuned station does not receive TP information for 5 seconds. TA SEEK The radio retunes to a different station which contains TP information. PI SOUND, PI MUTE When the vehicle is crossing the area where two stations with same AF but different PI code can be received at the same time, the receiver will become unstable, under this situation two modes can be selected. RETUNE L, RETUNE S To determine the initial time of automatic TA Search or PI Search. [. . . ] The unit shows these sorted files and directories by TUNE UP / DOWN Button (TUNE DOWN First). If the selected name is directory, the user can go into the selected directory by press MP3 BUTTON and continue to search the directory or file name in the directory by TUNE UP / DOWN Button (TUNE DOWN First). The selected file can be played by pressing MP3 Enter Button The distribution of alphabetical characters are listed as follow : Button Character M1 M2 M3 M4 M5 M6 SUB SOURCE TUNE DN TUNE UP ID3 DISPLAY SEL VOL UP/DN A, B, C D, E, F G, H, I J, K, L M, N, O P , Q, R S, T, U V, W, X Y, Z, Space _, -, + Move Cursor Next/Previous Character E - 13 (2) SEARCH DIRECTORY / TRACK NAME BY USING VOLUME KNOB Under MP3 Play Mode, press MP3 MENU BUTTON twice, the display shows " * ". The unit searches files and directories which have the same character which is inputted by the user. [. . . ]