User manual BOSS ONYX N12DVC

[. . . ] Use only the parts included with the unit to ensure proper installation. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30°° from horizontal, the unit might not give its optimum performance. [. . . ] When the release button is pressed and the D. C. P is unlocked, the car's vibrations may cause it to fall. To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. Socket Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P . E-5 5. WIRING DIAGRAM (20 PIN HARNESS PLUG) FUSE ANTENNA JACK ANTENNA DIN SOCKET 8 PIN CD CHANGER (OPTION) RED BLUE SUB WOOFER WHITE R-CH 20-PIN AUDIO/POWER HARNESS (See Figure 1) WHITE AUX IN L-CH YELLOW RCA-TO-RCA CABLES (not supplied) SUB WOOFER REAR LINE OUT GREY WHITE L-CH RCA-TO-RCA CABLES (not supplied) R-CH RED WHITE RED FRONT LINE OUT BLACK R-CH L-CH AMP BLUE Power Antenna Connect to power antenna or amplifier, If not used, tape bare end of wire. BLACK Ground Connect to ground terminal or Pclean unpainted metal part of chassis Memory/Battery YELLOW Connect to battery or 12 volt power sourse that is always live. The radio will not work if this wire is not connected RED Accessory/Ignition Connect to existing radio wire or radio fuse. 20-PIN AUDIO/POWER HARNESS LEFT FRONT WHITE-BLACK LFWHITE LF+ RIGHT FRONT GREY-BLACK RF1 GREY RF+ 2 3 4 5 6 7 8 9 10 LEFT REAR GREEN-BLACK LR GREEN LR+ RIGHT REAR VIOLET-BLACK RRVIOLET RR+ 11 12 13 14 15 16 17 18 19 20 Figure 1 Pin View PIN 1 2 3 4 5 6 7 8 9 10 WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK GREEN GREEN/BLACK RED BLACK RED FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT PIN 11 12 13 14 15 16 17 18 19 20 WIRE COLOR WHITE WHITE/BLACK BLUE YELLOW BLACK WHITE RED BLACK WHITE FUNCTION/LABEL LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) POWER ANTENNA BATTERY(+) CHASSIS GROUND LEFT FRONT PRE-AMP LINE OUT RIGHT FRONT PRE-AMP LINE OUT FRONT PRE-AMP LINE OUT COMMON LEFT REAR PRE-AMP LINE OUT E-6 6. PANEL OPEN/CLOSE OPERATION (MOTORIZED SLIDE DOWN VERSION) This unit is equipped with the most advanced full logic motorized slide down system. You can enjoy this advance technology with just a single press of the "OPEN" button Please read the following instructions carefully before operating the unit. OPEN / CLOSE THE PANEL: Press the Open button to open a closed panel, or to close an opened panel. LOADING A CD When the panel is in the slide down position, the disc slot becomes accessible. Insert a CD through the disc slot, the CD will be automatically loaded and the panel will also close automatically & playback will begin. EJECTING A CD Press and hold Open button for more than 3 seconds to slide down the panel, if a CD is loaded, it will be ejected automatically. 17) PRESET EQUALIZER BUTTON (EQ) Press this button to toggle the following EQ settings: FLAT->CLASSICS->POP M->ROCK M->DSP OFF At DSP OFF mode, EQ will be controlled by Bass/Treble setting. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) Press the Band/Loudness Button for couple of seconds to switch the loudness on or off. When Loudness is on, display will show 'Loud On' for a few seconds. E-9 9. RADIO OPERATIONS 11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. 2. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. 7) STATION PRESET BUTTONS (M1-M6) 1. Press these buttons briefly to recall the stored stations in the selected band. 2. Presetting stations manually, Press the BAND button to select the band for the stations to be preset. Press the Preset button at which you want to store the station for at least 2 second. The preset number will appear on the display accompanied by a beep, this indicates that the station has been stored into memory. Press this button shortly to change between BAND FM1, FM2, FM3 or AM/MW bands. Press this button for couple of seconds to turn Loudness function on or off. [. . . ] Once the desired tack is reached, press Scan button to cancel scan mode and CD play will be started at the last scanned track. PAUSE BUTTON Pressing this button during CD play, and it will stop the play mode, press this button again to resume CD play from the last position. E - 12 12. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 OPERATIONS: Key 1. Audio Radio Mode Power On/Off CD Player Mode Power On/Off CDC Player Mode Power On/Off Adjust Vol, Bas, Tre, Fad, Bal Display Clock, Spectrum FM Mono/ Stereo Tuning/Seek Up/Down Local /Distant Adjust Vol, Bas, Tre, Fad, Bal Display Clock, Spectrum Adjust Vol, Bas, Tre, Fad, Bal Display Clock, Spectrum No Function Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal Station Scan Mute Select Vol, Bas, Tre, Fad, Bal 10. Sub-woofer(SUB)/ Sub-woofer/ Change to CD or CD Changer Source or AUX IN Sub-woofer/ Change to Radio or CD Changer or AUX IN Sub-woofer/ Change to Radio or CD or AUX IN 11. [. . . ]