User manual BOSS CHAOS SE800

[. . . ] Do not use second-hand or rental CDs that have a sticky residue on the surface (for example, from peeled-off stickers or from ink, or glue leaking from under the stickers). There are paste residue. Ink is sticky (P . 5). ******* **** ******* ******* ******* P1 . Do not stick paper or tape on the disc (P P5 . Do not use CDs with old labels that are beginning to peel off. Stickers that are beginning to peel away, leaving a sticky residue (P . 6). P6 . (Europe) (Europe) (U. S. A. ) FM FM FM Frequency Coverage: 87. 5 to 108 Mhz 87. 5 to 108 Mhz 87. 5 to 107. 9MHz IF 10. 7 Mhz 10. 7 Mhz 10. 7 Mhz Sensitivity (S/N = 30dB): 20 dBu 20dBu 20 dBu P2 . ************** ******* ******* ******* 3. [. . . ] Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30 from horizontal, the unit might not give its optimum performance. 30 Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive vibration. Be sure to remove the front panel before installing the unit. DIN FRONT/REAR-MOUNT BAND NAME AMERICAN 1 AMERICAN 2 EUROPE 10 EUROPE 5 MID EAST AUST (AUSTRALIA) RUSSIA JAPAN FREQUENCYRANGE FM:87. 5-108MHz FM:87. 5-107. 9MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:65. 0-74MHz FM:76. 0-90. 0MHz AM:530-1710kHz AM:530-1710kHz AM:522-1620kHz AM:522-1620kHz AM:531-1602kHz AM:522-1593kHz AM:522-1620kHz AM:522-1629kHz This unit can be property installed either from Front (conventional DIN Front-mount) or Rear (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation methods A and B. DIN FRONT-MOUNT (Method A) Installation the unit 1 182 2 53 To change the range to suit your location, press DOWN ARROW until the desired frequency range is hight lighted. The press > to save it and move to next setting area. -AUX Input Enable/Disable Press DOWN ARROW to move between Enable and Disable modes. When the selection has been made, press> to save it and move to next setting area or press ENTER to leave the System Setting mode. If Aux Input is disable in System Settings, anyinput connected will not be played. 3 1. Holder After inserting the half sleeve into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. Screw 1 5 3 -Clock Format (12-hour or 24-hour) Press DOWN ARROW to move between 12-hour and 24-hour format, press > to save it and move to next setting area or press ENTER to leave the System Setting mode. 1. 3. ) MODE Press the button repeatly to cycle through the audio input sources: RADIO>CD>USB>SD CARD>AUX IN 4. ) AUX IN This jack is a convienent way to play music from MP3 player such as iPod throguh your car stereo. Simply connect headphone output from MP3 player to this input jack. Press MODE to select AUX as input source and begin to play music on the MP3 player. To set a preset, tune the desire radio station, then press and hold the preset you wish to assign that station more then one second and release. To replace it with different station, repeat the precess and the new setting will override the previous one. 6. ) BAND Press briefly, repeatedly to cycle through five radio bands: FM1>FM2>FM3>AM1>AM2 7. ) TUNE/SEEK UP/DOWN BUTTON Press this button briefly to step up or down the radio dail in single step increments. In this mode the tuner will stop at the next strong station avaliable. 8. ) REL Press to drop down the detachable front panel to insert CD or SD Card. 9. ) AMS (Auto Memories Scan) This is the easiest way to set up the preset station in each radio band. 7. ) SELECT Press this button to cycle through the following adjustable settings: VOLUME>BASS>TREBLE>BALANCE >FADER>EQUALIZER 8. ) MO/ST In some areas, the reception of FM stations may be weak. Change the reception mode to MONO by pressing the button may improve the reception. [. . . ] 2. ) RDM (Random Play Mode) Press this button to play all MP3 files in random order. Press again to cancel. 1 2 7 1 2 4 5 6 8 10 9 3. ) STOP Press to stop playback. Press PLAY PAUSE to begin playback on the first track (NOT the track on last play) 4. ) PLAY/PAUSE Files will begin to play automatically. 5. ) RPT (Repeat Play Mode) Press this button to repeat all the playback automatically. [. . . ]