User manual BOSS CHAOS WIRED CW2000M

[. . . ] Replace with a good sensitivity whip antenna 1 182 2 53 3 1. Holder After inserting the half sleeve into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. Screw NOTES:Good ground connections eliminate most electrical noise problems and require tight contact with the metal vehicle chassis. Remove plastics, paint, or rust for good electrical contact 1 5 3 2 4 1. [. . . ] The strap can be bent by hand to the desired angle. -2- - 11 - Setting Mode: You can make changes to the system setting in the following area: Radio Frequency Range + Enable/Disable AUX In + Clock Format The display will show TEST MOD breifly to indicate you are in system setting area and then automatically change to Radio Frequency selection mode. At any time, you can press the > button to step through the above areas. - Radio Settings The unit can operate on serveral different frequency ranges. The default frequency range is AMERICAN 2 . BAND NAME FREQUENCY RANGE Removing the unit a a . Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. AMERICAN 1 AMERICAN 2 EUROPE 10 EUROPE 5 MID EAST AUST (AUSTRALIA) RUSSIA JAPAN FM:87. 5-108MHz FM:87. 5-107. 9MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz AM:520-1710kHz AM:530-1710kHz AM:522-1620kHz AM:522-1620kHz AM:531-1602kHz AM:522-1593kHz AM:522-1620kHz AM:522-1629kHz To change the range to suit your location, press DOWN ARROW until the desired frequency range is hightlighted. -AUX Input Enable/Disable Press DOWN ARROW to move between Enable and Disable modes. When the selection has been made, press > to save it and move to next setting area or press ENTER to leave the System Setting mode. If Aux Input is disable in System Settings, any input connected will not be played. -Clock Format (12-hour or 24-hour) Press DOWN ARROW to move between 12-hour and 24-hour format, press > to save it and move to next setting area or press ENTER to leave the System Setting mode. - 10 - -3- General And Radio Control 2 1 6 4 Specifications Supply voltage Current consumption Audio signal output Characteristics Frequency coverage : 12V DC(11V-15V) : Less than 15A : 2 CH line out : Frequency response: 100Hz 10KHz : AM 530 - 1710KHz ; FM 87. 5 - 107. 9MHz 3 7 8 5 1. ) VOLUME UP/DOWN KNOB (TURN) AUDIO MODE SELECTOR (PRESS) In normal mode, use this knob to increase / decrease the volume level. Change the reception mode to LOC by pressing the button may improve the reception. 7. ) SELECT Press this button to cycle through the following adjustable settings: VOLUME>BASS>TREBLE>BALANCE >FADER>EQUALIZER 8. ) MO/ST In some areas, the reception of FM stations may be weak. Change the reception mode to MONO by pressing the button may improve the reception. Press again to return to STEREO 9. ) RADIO PRESET 1-6 After you preset the stations via front panel, you can use this buttons 1-6 to select the preset stations. 10. ) AMS (Auto Music Scan) This is the easiest way to set up the preset station in each radio band. If you press AMS, the radio will scan up all the strongest station and preset automatically. Press again to turn off Loudness function. 9 10 12 11 13 12. )BAND Press briefly, repeatly to cycle through five radio bands: FM1>FM2>FM3>AM1>AM2 13. ) SOURCE (Input select, same as MODE on head unit) Press the button repeatly to cycle through the audio input sources: RADIO>USB>SD CARD > AUX IN -8- -5- USB/SD Card (M P3 Playback) Control using remote control. . . . 1. ) I<< and >>I (Skip back / forward) Press those buttons to skip back or ahead one track. 2. ) RDM (Random Play Mode) Press this button to play all MP 3 files in random order. [. . . ] Press PLAY PAUSE to begin playback on the first track (NOT the track on last play) 4. ) PLAY/PAUSE Files will begin to play automatically. 5. ) RPT (Repeat Play Mode) Press this button to repeat all the playback automatically. 6. ) NUMERIC PAD Press the number key during playback to select particular track. [. . . ]