Detailed instructions for use are in the User's Guide.
[. . . ] Use only the parts included with the unit to ensure proper installation. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. [. . . ] To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc.
Socket
Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P .
E-5
5. WIRING DIAGRAM (20 PIN HARNESS PLUG)
FUSE
ANTENNA JACK
ANTENNA
R-CH
20-PIN AUDIO/POWER HARNESS (See Figure 1)
WHITE
L-CH
YELLOW
AUX IN
RED
BLUE
SUB WOOFER WHITE
RCA-TO-RCA CABLES (not supplied)
SUB-WOOFER
REAR LINE OUT GREY
WHITE RED
R-CH
RCA-TO-RCA CABLES (not supplied)
L-CH
FRONT LINE OUT BLACK
WHITE RED
R-CH L-CH
AMP
BLUE
Power Antenna Connect to power antenna or amplifier, If not used, Tape bare end of wire.
BLACK
Ground Connect to ground terminal or Clean unpainted metal part of chassis
Memory/Battery YELLOW Connect to battery or 12 volt power source that is always live.
The radio will not work if this wire is not connected
RED Accessory/Ignition Connect to existing radio wire or radio fuse.
20-PIN AUDIO/POWER HARNESS
LEFT FRONT WHITE-BLACK LFWHITE LF+
RIGHT FRONT GREY-BLACK RF1 GREY RF+ 2 3 4 5 6 7 8 9 10
LEFT REAR GREEN-BLACK LR GREEN LR+
RIGHT REAR VIOLET-BLACK RRVIOLET RR+
11
12
13
14
15
16
17
18
19
20
Figure 1
Pin View
PIN 1 2 3 4 5 6 7 8 9 10
WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK GREEN GREEN/BLACK RED BLACK RED
FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT
PIN 11 12 13 14 15 16 17 18 19 20
WIRE COLOR WHITE WHITE/BLACK BLUE YELLOW BLACK WHITE RED BLACK WHITE
FUNCTION/LABEL LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) POWER ANTENNA BATTERY(+) CHASSIS GROUND LEFT FRONT PRE-AMP LINE OUT RIGHT FRONT PRE-AMP LINE OUT FRONT PRE-AMP LINE OUT COMMON LEFT REAR PRE-AMP LINE OUT
E-6
6. PANEL OPEN/CLOSE OPERATION (MOTORIZED SLIDE DOWN VERSION)
This unit is equipped with the most advanced full logic motorized slide down system. You can enjoy this advance technology with just a single press of the "OPEN" button Please read the following instructions carefully before operating the unit. OPEN / CLOSE THE PANEL: Press the Open button to open a closed panel, or to close an opened panel. LOADING A CD When the panel is in the slide down position, the disc slot becomes accessible. Insert a CD through the disc slot, the CD will be automatically loaded and the panel will also close automatically & playback will begin. EJECTING A CD Press and hold Open button for more than 3 seconds to slide down the panel, if a CD is loaded, it will be ejected automatically. If the ejected CD is not being removed, after 10 seconds it will be reloaded automatically. When Loudness is on, display will show 'Loud On' for a few seconds.
E-9
9. RADIO OPERATIONS
11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. 2. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. 7) STATION PRESET BUTTONS (M1-M6) 1. Press these buttons briefly to recall the stored stations in the selected band. 2. Presetting stations manually, Press the BAND button to select the band for the stations to be preset. Press the Preset button at which you want to store the station for at least 2 second. The preset number will appear on the display accompanied by a beep, this indicates that the station has been stored into memory. Press this button shortly to change between BAND FM1, FM2, FM3 or AM/MW bands. Press this button for couple of seconds to turn Loudness function on or off. DUAL FREQUENCY (AMERICAN + EUROPEAN ) SELECTOR The unit is factory defaulted American frequency. In case if European frequency is required, first disconnect the power supply, adjust the selector switch located under the unit to the desired frequency by using a small screw, and then reconnect the power supply. [. . . ] If the MP3 file is available with ID3 TAG, pressing the display button repeatedly will show information in the following sequence: SONG TITLE > ARTIST> ALBUM TITLE > YEAR> COMMENTS If any of the ID3-TAG information is not available, pressing the DISPLAY button repeatedly will show information in the following sequence: UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE > UNKNOWN YEAR > NO COMMENTS If the MP3 file is without ID3 TAG, pressing the DISPLAY button, & "NO ID3 TAG" will be displayed. The file name & track number of the MP3 file will scroll repeatedly through the display during the playing of the MP3 file.
E - 13
12. REMOTE CONTROL
1 2 3 4 5 6 7 8 9 10 11 12 13 14
OPERATIONS:
Key
1. ID3/DISP
Radio Mode
Power On/Off
CD Player Mode
Power On/Off
MP3 Mode
Power On/Off
Adjust Vol, Bas, Tre, Fad, Bal Display Clock
Adjust Vol, Bas, Tre, Fad, Bal
Display Clock
Adjust Vol, Bas, Tre, Fad, Bal ID3 Tag information Display Clock, Numeric key 0*
4. Stereo/Mono
Stereo/FM Mono
Tuning/Seek Up/Down Local/Distant Station Scan Mute
Select Vol, Bas, Tre, Fad, Bal
No Function
Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal
No Function
Track Up/Down/ Numeric key 8*9* No Function No Function Mute
Select Vol, Bas, Tre, Fad, Bal,
5. Band/Loud/ Enter
Sub-woofer/ Change to CD/MP3 or AUX IN Band/Loudness
Auto Store/Preset Scan Preset EQ Preset station 1 Preset station 2 Preset station 3 Preset station 4 Preset station 5 Preset station 6
Sub-woofer/ Change to Radio or AUX IN
Sub-woofer/ Change to Radio or AUX IN / Numeric key 7*
Loudness No function
Preset EQ Pause CD scan Repeat Shuffle No Function No Function
Loudness/ MP3 Enter Menu function
Preset EQ
12. [. . . ]