User manual BOSS CHAOS SE122DVC

[. . . ] Use only the parts included with the unit to ensure proper installation. Consult with your nearest dealer if installation requires drilling holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. [. . . ] To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. Socket Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P . E-5 5. WIRING DIAGRAM ANTENNAJACK ANTENNAPEXT ENDERP CABLE FUSE L-CH 20-PIN AUDIO/POWER HARNESS (See Figure 1) AUX IN WHITE SUB WOOFER YELLOW BLUE WHITE RCA-TO-RCA CABLES (not supplied) SUB-WOOFER RED R-CH REAR LINE OUT GREY WHITE RED R-CH L-CH RCA-TO-RCA CABLES (not supplied) FRONT LINE OUT BLACK WHITE RED R-CH L-CH AMP PIN(B8) GREEN/BLACK PIN(B2) VIOLET/BLACK PIN(B6) WHITE/BLACK PIN(B4) GREY/BLACK PIN(B7) GREEN PIN(B1) VIOLET PIN(A8) BLACK PIN(B5) WHITE PIN(B3) GREY ISO CONNECTOR (See Figure 2) CONNECTOR B PIN A4 A5 A7 A8 B1 B2 B3 B4 B5 B6 B7 B8 7 5 3 1 8 6 4 2 7 5 3 1 8 6 4 2 PIN(A5) BLUE PIN(A7) RED PIN(A4) YELLOW CONNECTOR A PIN 1 WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) Figure 2 2 3 ISO CONNECTOR 4PIN+8PIN FEMALE WITH MALE TERMINAL 4 5 6 GREEN GREEN/BLACK RED LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) ISO CONNECTOR WIRING CHART WIRE COLOR YELLOW BLUE RED BLACK VIOLET VIOLET/BLACK GREY GREY/BLACK WHITE WHITE/BLACK GREEN GREEN/BLACK FUNCTION/LABEL BATTERY(+) POWER ANTENNA IGNITION(ACC) GROUND RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT FRONT SPEAKER (-) LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) 7 8 9 10 11 12 13 14 15 16 17 18 19 20 BLACK RED WHITE WHITE/BLACK BLUE YELLOW BLACK WHITE RED BLACK WHITE POWER ANTENNA BATTERY(+) CHASSIS GROUND LEFT FRONT PRE-AMP LINE OUT RIGHT FRONT PRE-AMP LINE OUT FRONT PRE-AMP LINE OUT COMMON LEFT REAR PRE-AMP LINE OUT E-6 6. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12) POWER ON/OFF BUTTON Press this button to turn on or off the power. 5) DISPLAY BUTTON (DISP) Press this button to view Program Type (PTY), and Frequency of the station that you are listening to. 16) SOURCE BUTTON (SOURCE) Press this button to select Radio and CD modes. The available selections depends on version: Radio CD Player Radio > CD > AUX in Sub-woofer On/Off Press SOURCE button for more than 3 seconds to activate or turn off the Sub-woofer output. Aux Input Connect the external signal to the auxiliary line in jack located at the rear of the unit , then press Source button to select Aux mode. - Regional mode ON: AF Switching or PI SEEK is implemented to the station which have all PI codes same as current station. - Regional mode OFF: The Regional code in the format of PI code is ignored when AF switching or PI SEEK is implemented. E-9 Some broadcasting stations may change their program from normal broadcasting to regional broadcasting for a certain period. When regional mode is off, the region identification in the PI code is ignored; the radio may switch to a local variant of the current program. When region mode is on, the radio will only switch to a program carrying the exact same PI code. Note: When AF switch is on, at this moment use tuning up/down to search station will only stop at station which has RDS broadcasting. 8) TA BUTTON(TRAFFIC ANNOUNCEMENT) When pressed shortly, it is activated as TA mode on or off When TA mode is on and traffic announcement is transmitted. - When the unit is in CD mode, it will switch to radio mode temporarily. - If the volume level was under the threshold point, it will be raised to the threshold point. - When TP station is received, TP segment is turned on in LCD display. When pressed for couple of seconds, EON TA LOCAL /EON TA DISTANCE mode is selected. - EON TA LOCAL mode When the field strength level of EON linked is less than the threshold level. [. . . ] The receiver will switch to radio mode automatically. EJECT BUTTON E - 12 10. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 OPERATIONS: Key 1. DISP 4. TA Radio Mode Power On/Off CD Player Mode Power On/Off Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal Display Clock TA Function Tuning/Seek Up/Down AF Function PTY Function Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal 5. Band/Loud Sub-woofer/ Change to CD or AUX IN Band/Loudness Auto Store/Preset Scan Preset EQ Preset station 1 Preset station 2 Preset station 3 Preset station 4 Preset station 5 Preset station 6 Sub-woofer/ Change to Radio or AUX IN Loudness No function Preset EQ Pause CD scan Repeat Shuffle No Function No Function 12. Numeric Key(1) (2) (3) (4) (5) (6) E - 13 11. SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ratio Compact disc audio system Compact disc 44. 1KHz 1bit 5-20, 000Hz 2 stereo 70dB FM Frequency Range Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio 87. 5-108MHz 10. 7 MHz Better than 15dB at S/N 30 dB 25 dB at 1KHz 50 dB GENERAL Power Supply Polarity Speaker impedance Power Output DC 11 -14V Negative Ground 4 ohms 4x 50 Watts REMARK : Specifications subject to change without notice. E - 14 12. TROUBLE SHOOTING Before going through the check list, check wiring connection. [. . . ]