User manual BOSS BV9060B

[. . . ] Use only the parts included with the unit to ensure proper installation. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance. [. . . ] Attach the panel at the right side first, with point B on the main unit touching point A on the D. C. P (As shown on the digram). unit until a "click" sound is heard. CAUTION DO NOT insert the D. C. P from the left side. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. When the release button is pressed and the D. C. P is unlocked, the car's vibrations may cause it to fall. To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. Socket Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P . E-5 5. WIRING DIAGRAM (20 PIN HARNESS PLUG) ANTENNAJACK ANTENNAPEXT ENDERP CABLE FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) AUX IN WHITE L-CH YELLOW SUB WOOFER BLUE RCA-TO-RCA CABLES (not supplied) SUB-WOOFER R-CH WHITE RED REAR LINE OUT GREY WHITE RED R-CH RCA-TO-RCA CABLES (not supplied) L-CH FRONT LINE OUT BLACK WHITE RED R-CH L-CH AMP BLUE Power Antenna Connect to power antenna or amplifier, If not used, Tape bare end of wire. BLACK Ground Connect to ground terminal or Clean unpainted metal part of chassis Memory/Battery YELLOW Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected RED Accessory/Ignition Connect to existing radio wire or radio fuse. 20-PIN AUDIO/POWER HARNESS LEFT FRONT WHITE-BLACK LFWHITE LF+ RIGHT FRONT GREY-BLACK RF1 GREY RF+ 2 3 4 5 6 7 8 9 10 LEFT REAR GREEN-BLACK LR GREEN LR+ RIGHT REAR VIOLET-BLACK RRVIOLET RR+ 11 12 13 14 15 16 17 18 19 20 Figure 1 Pin View PIN 1 2 3 4 5 6 7 8 9 10 WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK GREEN GREEN/BLACK RED BLACK RED FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT PIN 11 12 13 14 15 16 17 18 19 20 WIRE COLOR WHITE WHITE/BLACK BLUE YELLOW BLACK WHITE RED BLACK WHITE FUNCTION/LABEL LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) POWER ANTENNA BATTERY(+) CHASSIS GROUND LEFT FRONT PRE-AMP LINE OUT RIGHT FRONT PRE-AMP LINE OUT FRONT PRE-AMP LINE OUT COMMON LEFT REAR PRE-AMP LINE OUT E-6 6. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12) POWER ON/OFF BUTTON Press this button to turn on or off the power. 14) TUNING / SEEK UP AND TUNING / SEEK DOWN BUTTONS 1. Press these buttons briefly, and the unit will operate in AUTO SEARCH tuning mode, the radio will tune up or down to the next station and remain on that station. 2. Press these buttons for more than 2 seconds, operate as MANUAL SEARCH buttons, under this mode the tuning frequency will advance up or down rapidly when the button is pressed. If the buttons are not pressed within 3 seconds, they will return to auto search mode. 8) MONO STEREO BUTTON (MO/ST) When you receive a station, "ST" on the display will be on. 9) SCAN BUTTON(SCAN) Press this button, the radio will tune up to search stations, the available stations will blink and stay on the display for a few seconds. 6) LOCAL/DISTANT BUTTON (LOC) During station tuning, this button allows you prior to access strong local station only (Local mode), or to access a wider range of using distant mode (DX). When powered on, DX mode will be defaulted automatically; Press LOC button briefly to select Local mode and "LOCAL symbol " on the LCD will light up for a few seconds. E-9 9. CD OPERATIONS M1) PAUSE BUTTON (PAUSE) Press this button to pause CD play, press again to release pause. M2) SCAN BUTTON (SCAN) Press this button, the first 10 seconds of each track will be played sequentially until this button is pressed again, then normal play will resume at the current track. M3) REPEAT BUTTON (REPEAT) Press this button, the current track will be played repeatedly until this button is pressed again. M4) SHUFFLE BUTTON (SHUFFLE) Press this button to play all tracks on CD in random. 14) TRACK UP AND TRACK DOWN BUTTON Press the Track Up Button to skip to the next track or previous track. [. . . ] The file name & track number of the MP3 file will scroll repeatedly through the display during the playing of the MP3 file. E - 12 11. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 OPERATIONS: Key 1. ID3/DISP Radio Mode Power On/Off CD Player Mode Power On/Off MP3 Mode Power On/Off Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal ID3 tag information Display Clock, Numeric key 0* 4. Stereo/Mono Stereo/FM Mono Tuning/Seek Up/Down Local/Distant Station Scan Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down/ Numeric key 8*9* No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal, 5. Band/Loud/ Enter Sub-woofer/ Change to CD/MP3 or AUX IN Band/Loudness Auto Store/Preset Scan Preset EQ Preset station 1 Preset station 2 Preset station 3 Preset station 4 Preset station 5 Preset station 6 Sub-woofer/ Change to Radio or AUX IN Sub-woofer/ Change to Radio or AUX IN/ Numeric key 7* Loudness No function Preset EQ Pause CD scan Repeat Shuffle No Function No Function Loudness/ MP3 Enter Menu function Preset EQ 12. Numeric Key(1) (2) (3) (4) (5) (6) Pause CD scan Repeat Shuffle Folder Down Folder Up E - 13 12. SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ratio Compact disc audio system Compact disc 44. 1KHz 1bit 5-20, 000Hz 2 stereo 70dB RADIO SECTION FM Frequency Range Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio 87. 5-107. 9MHz 10. 7 MHz Better than 15dB at S/N 30 dB 25 dB at 1KHz 50 dB AM/MW Frequency Range Intermediate Frequency Usable Sensitivity S/N Ratio 530-1710KHz 450KHz Better than 45dB 40 dB GENERAL Power Supply Polarity Speaker impedance Power Output DC 11 -14V Negative Ground 4 ohms 4x 50 Watts REMARK : Specifications subject to change without notice. E - 14 13. TROUBLE SHOOTING Before going through the check list, check wiring connection. [. . . ]