User manual BOSS 814CA

[. . . ] Use only the supplied mounding hardware for a safe and secure installation. REINSTALLATIONS A If there is installation hardware for another receiver already in the dashboard, it must be removed. Before installing the unit in the dashboard, Remove the trim plate from the unit. [. . . ] It will cause the unit to be damaged. Ground Connection Connect Black Wire to Ground terminal. Step3 Power Connection First connect the Yellow Wire (w/15Amp fuse block) directly to +12v constant power. Caution: If a fuse is blown, only replace it with one of the same rating. A thorough inspection is recommended. Current Folder Navigate Step2 Step3 Step4 2 11 MP3 PLAYER OPERATION MP3 MODEL The following keys are assigned as MP3 disc plays. M5 and M6 is assigned Searching file or directory. AS/PS BAND M1 M2 M3 M4 M5 M6 SCAN T-DOWN T-UP DISPLAY SEL VOL UP/DOWN MODE SELECT ENTER A, B, C, 1 D, E, F, 2 G, H, I, 3 J, K, L, 4 M, N, O, 5 P, Q, R, 6 S, T, U, 7 V, W, X, 8 Y, Z, SP ACE, 9 _, -, +, 0 CHAR, SHIFT CHAR, SEL(A, B~8, 9, 0) WIRING DIAGRAM A A B C D Caution Make the connection correctly, as illustrated in the connection diagram. Do not connect the negative - cord of each speaker wire to a common point. Use of a fuse of a higher rating may cause serious damage to the unit. E IGNITION Black GROUND Red (ACC) 1A CONNECTION DIAGRAM abcd MP3 Direct Select Search and Navigate Modes Press AS/PS to select between the following MP3 Modes: Direct Numeric Track Select Alphanumeric Track or Folder Search Root Folder Navigate Current Folder Navigate Press AS/PS one time. Use the buttons in the above table (3 keystroke maximum input), or the rotary encoder to enter the desired track number. Press BAND/LOUDNESS to confirm the selected track number or, wait for the input cycle to time out (approximately 4 seconds). Use the buttons in the table on page 7 (16 keystroke maximum input) or the rotary encoder or enter the desired alphanumeric search characters. Press " "(or turn the rotary encoder to the down), first to preview the search results. NOTE: " " must be pressed first (or turn the rotary encoder to the down) to continue the search. Press BAND/LOUDNESS first, then " " (or turn the rotary encoder to the down) to begin searching the selected folder. NOTE: " " must be pressed first (or turn the rotary encoder to the down) to search within the folder. Press BAND/LOUDNESS to select the desired track within the folder. Yellow 15A (12V CONSTANT) Blue (AUTO ANT) POWER ANTENNA BATTERY Pink (POWER AMP) CONTROL RELAY Direct Numeric Track Select One or more of the connectors B , C and F may not exist on the model your car. Make the appropriate connection or connections according to the configuration of your unit. See the section "SPECIFICATIONS" of the separate Operating Instructions. b F a White White/black + + - + + - Grey A Grey/black Step2 Green Green/Black d c Violet Violet/Black B C D E Alphanumeric Track or Folder Search + + + + L R + + + + L R Step2 Step3 - - - - + + + + -L R + + + + + + L R From the car antenna CD Changer(option) RCA Audio output (Front and Rear). [. . . ] -Frequency moves one step up/down when press T-UP/DOWN key is pressed for less than 500ms. -SEEK MODE is activated as below when T-UP/DOWN key is pressed for longer than500ms. -SEEK1:SEEk is activated right away when key is pressed for longer than 500ms. [. . . ]