User manual BOSS 620CA

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BOSS 620CA. We hope that this BOSS 620CA user guide will be useful to you.


BOSS 620CA : Download the complete user guide (1989 Ko)

Manual abstract: user guide BOSS 620CA

Detailed instructions for use are in the User's Guide.

[. . . ] Do not use solvents such as benzine, thinner, commercially available cleaners, or antistatic spray intended for analog discs. Only for this unit. CD-Rs and CD-RWs which have not undergone finalization processing cannot be played. (For more information on finalization processing, refer to the manual for your CD-R/CD-RW writing software or CD-R/CD-RW recorder. ) Additionally, depending on the recording status, it may prove impossible to play certain CDs record on CD-R or CD-RW. 2 3. [. . . ] Attach the panel at the right side first, with point B on the main unit touching point A on the D. C. P (As shown on the digram). unit until a "click" sound is heard. CAUTION DO NOT insert the D. C. P from the left side. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. When the release button is pressed and the D. C. P is unlocked, the car's vibrations may cause it to fall. To prevent damage to the D. C. P always store it in a protective case after detaching it. , The rear connector that connects the main unit and the D. C. P is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. Socket Note: If the D. C. P is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the D. C. P . 5 5. WIRING DIAGRAM (20 PIN HARNESS PLUG) ANTENNA CABLE INPUT FUSE 20-PIN AUDIO/POWER HARNESS (See Figure 1) REAR LINE OUT GREY WHITE L-CH RCA-TO-RCA CABLES (not supplied) RED R-CH AMP Power antenna wire and remote turn on lead BLUE BLACK Ground Connect to ground terminal or Clean unpainted metal part of chassis YELLOW Memory/Battery Connect to a constant 12 volt source. The radio will not work if this wire is not connected. RED Accessory/Ignition - Connect to a switched 12 volt source. 20-PIN AUDIO/POWER HARNESS LEFT FRONT WHITE-BLACK LFWHITE LF+ RIGHT FRONT GREY-BLACK RF1 GREY RF+ 2 3 4 5 6 7 8 9 10 LEFT REAR GREEN-BLACK LR GREEN LR+ RIGHT REAR VIOLET-BLACK RRVIOLET RR+ 11 12 13 14 15 16 17 18 19 20 Figure 1 Pin View PIN 1 2 3 4 5 6 7 8 9 10 WIRE COLOR GREY/BLACK GREY VIOLET VIOLET/BLACK GREEN GREEN/BLACK RED BLACK RED FUNCTION/LABEL RIGHT FRONT SPEAKER (-) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER (-) LEFT REAR SPEAKER (+) LEFT REAR SPEAKER (-) IGNITION(ACC) REAR PRE-AMP LINE OUT COMMON RIGHT REAR PRE-AMP LINE OUT PIN 11 12 13 14 15 16 17 18 19 20 WIRE COLOR WHITE WHITE/BLACK BLUE YELLOW BLACK FUNCTION/LABEL LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER (-) POWER ANTENNA BATTERY(+) CHASSIS GROUND WHITE LEFT REAR PRE-AMP LINE OUT 6 6. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12) POWER ON/OFF BUTTON Press this button to turn on or off the power. 5) DISPLAY BUTTON (DISP) Press this button briefly, the LCD will display the clock for about 2 seconds, then return to previous display mode. Clock Adjustment Under clock display mode, press DISP button until the LCD flashes, press Tuning Up Button to adjust hour and Tuning Down Button to adjust minute. 16) SOURCE BUTTON (SOURCE) Press this button to select Radio and CD modes. The available selections depends on version: Radio CD Player Radio > CD 18) FRONT AUXILIARY INPUT JACK Connect the external signal to AUX in jack located at the front of the panel , then press SOURCE button to select Aux mode. Press SOURCE button again to cancel Aux mode and return to previous mode. AUX IN JACK IN PANEL 1 2 3 Left Audi o Right Audi o Gr ound RESET BUTTON 3. 5mm Audi o In Cabl e (not in cluded) The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. [. . . ] Symptom No power Cause The car ignition is not on. Solution If the power supply is properly connected to the car accessory terminal, switch the ignition key to "ACC" Replace the fuse. Front panel is not properly fixed into its place Adjust the installation angle to less than 30 degrees. The fuse is blown. Disc cannot be loaded or ejected Presence of CD disc inside the player. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BOSS 620CA




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BOSS 620CA will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.